Electric Brake Controller Recommendation for Winnebago with 7-Way Installed
Question:
I need to order a complete system to hard wire my trailer to a 1996 winnebago Itasco Suncruiser with a Ford 460 engine. The trailer is already set up with brakes with 7 point plug. Please advise which controller and wiring, plugs, etc. I need to order. Your quick response is appreciated.
asked by: Tom
Helpful Expert Reply:
Since you have a 7-Way you will only need a few more components to complete a brake controller install on your vehicle.
First let's start with a brake controller. I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to set up.
Next, for a wiring kit to install the brake controller to the 7-way you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.
Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.
I attached an FAQ on installing brake controllers for you to check out.
Products Referenced in This Question
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford, Lincoln, Mercury
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Recommended Replacement Brakes for a 2007 Pace Trailer w/ 15 Inch Rims
- Q&A: Parts Needed To Install a 7-Way and Trailer Brake Controller On a 1996 Ford F-350 With Factory 4-Way
- Q&A: Availability of Trailer Hitch for 2023 Mercedes-Benz GLE 350
- Q&A: Installing A Reese Brakeman Controller In A 202 Ford E250 With Factory 4-Flat
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Where is the Brake Controller Port on a 1996 Ford F250 7.3
- Q&A: Installing Trailer Wiring on a 2014 Ford Explorer
- Article: How to Charge RV Batteries
- Article: RV Electrical Power Systems
- Q&A: Recommended Trailer Hitch for a 2022 Lexus RX 350