Brake Controller and Trailer Wiring for 1997 Ford F-350 Utility Body Without Factory Wiring
Question:
NO TRAILER PLUG AT REAR OF BODY, HAVE FOUND 4 WIRES TAPED TOGETHER ON INSIDE OF FRAME NEAR FUEL TANK, THESE CARRY SIGNAL FOR TURN AND TAIL, BUT SHOULD THERE BE ANOTHER PLUG ON THIS CHASSIS THAT ALREADY HAS PIGTAIL TO MATCH AND PLUG AND PLAY. LOOKING TO ADD #90195 E BRAKE CONTROLLER, WITH ETBC7 ADAPTER KIT, TO ADD TRAILER LIGHTING AND TRAILER BRAKE SIGNAL TO A 2 AXLE TRAILER DUMP.
asked by: ROBERT P
Expert Reply:
The Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C55316 is what you need if there is a factory connection near the rear bumper like pictured on the driver's side. If it is there, then you will use the Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires # ETBC7.
If that connector isn't present, then I recommend using the 7-Way Pre-Wired Car Connector, 7' Lead # 20023 to get to the wires you mentioned and the connector at your bumper. Then use the universal brake controller wiring kit # 5506 to connect the Prodigy P3 # 90195 you referenced.
The hardwiring will be very similar to the ETBC7 article attached.
Products Referenced in This Question
7-Way Pre-Wired Car Connector, 7' Lead
- Custom Fit Vehicle Wiring
- Fifth Wheel and Gooseneck Wiring
- 7 Feet Long
- Universal Fit
- 7 Round - Blade
- Draw-Tite
more information >
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Curt TriFlex NEXT Trailer Brake Controller - 1 to 4 Axles - Proportional
- Shop: Trailer Wiring
- Shop: Brake Controller
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Article: Trailer Wiring Diagrams
- Search Results: 90885
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Shop: Valterra Keyed Entry Door Knob w/ Interior Lever for RVs - Stainless Steel
- Shop: Vehicle Tow Bar Wiring
- Shop: Vehicle Engine Heaters
- Shop: Bug Shield
- Shop: Transmission Cooler
- Shop: Trailer Hitch
- Shop: Weather Tech Easy-On Stone and Bug Shield Deflector
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class V XD - 2"
- Shop: Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness w/ 7-Pole Connector - 6' Long
- Q&A: Installation of 7-Way Connector on a 1997 Ford F-350
- Search Results: brake controller wiring
- Search Results: trailer brake controller wiring
- Q&A: Compatible Entry Door Locking Latch For A 2005 Jayco Jay Series 1600 Pop Up Camper
- Search Results: door knob
- Search Results: brake controller
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Video: Choosing the Right Trailer Wiring
- Search Results: trailer brake controller
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Choosing the Right Brake Controller
- Search Results: etbc7
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug