Head Unit Dimensions of the Lippert Electric Trailer Jack # LC285318
Question:
Can you supply dimensions from the front of the upper jack housing to the jack tube and from the rear of the upper jack housing to the jack tube. I want to make sure I have clearance to my open tailgate and to my propane tanks.
asked by: Christopher W
0
Expert Reply:
I went out to the warehouse and measured the Lippert Electric Trailer Jack # LC285318 for you. From the center of the tube to the font part of the housing measured about 6-1/2" while that same measurement to the back of the housing was about 2-1/2".
Attached is a photo to demonstrate this.
expert reply by:
Jon G
0
Product Page this Question was Asked From
Lippert Electric Trailer Jack with Footplate - A-Frame - 18" Lift - 3,500 lbs - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jack
- Leveling Jacks
- Tongue Jack
- Steel
- 3001 - 4000 lbs
- Electric Jack
- Bolt-On
- 1 Jack
- Lippert
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: Weight Distribution Recommendation for a 2024 Jayco Flight 284BHS
- Article: Trailer Wiring Diagrams
- Q&A: Replacement 3500-lb Electric Tongue Jack for Lippert 1817941
- Q&A: What Kayak Carriers Will Fit The Thule TracRac TracONE Crossbars
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Q&A: Which Nev-R-Adjust Brake Assemblies for Load Trail 14K Dump Trailer
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Most Popular Wheel Bearings
- Article: Best Camper Jacks
- Article: RV Pre-Departure Checklist
- Article: Trailer Jacks
- Article: How (and Where) to Connect an RV Propane Grill