Replacement for Atwood Water Heater Switch

Question

Question:

I cannot seem to locate the water heater switch on my 2004 pioneer travel trailer

asked by: George M

0

Expert Reply:

We do not have any way to know where an individual switch is located on a trailer; the best we can do is offer a replacement switch. For a single-panel switch you would need the Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters # AT91959 (Black) or # AT91859 (White).

If you needed a double-panel switch there is the Replacement Double-Panel On/Off Switch for Atwood Gas and Electric Combination Water Heaters # AT91230.

expert reply by: Kyle S

0

Answer 1

The only way I can recommend you wire up the Atwood Switch part #AT91959 is by using the attached diagram which means using a 12 volt power source. I don't have a way we can recommend using a 110.

view full answer...

Answer 2

Since you don't have the wiring harness on your previous RV water heater you most likely had an all propane powered unit. The Atwood RV Water Heater w/ Heat Exchange - Gas and Electric - Automatic Pilot - 8,800 Btu - 6 Gal #AT96163 is powered…

view full answer...

Answer 3

There are many variables when installing the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters part #AT91230 therefore it is best to match the wire to the terminals using its function, not the color. The reason for this…

view full answer...

Answer 4

I reached out to my contact at Dometic and he agreed that your switch needs to be replaced. You can use one of the following: Dual Switch White - #AT91230 Single Switch White - #AT91859 Black - #AT91959 Attached is a photo showing the wiring…

view full answer...

Answer 5

It sounds like the purpose of getting the air helper spring would be to counteract the 1 inch compression you're getting in your rear suspension caused by the pin weight of your 5th wheel. If that's the case, I believe that the AirLift 5000…

view full answer...

Answer 6

You won't want to wire both functions to a single switch like the Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters - Black #AT91959 since it wouldn't allow for proper functioning. You would want to wire each…

view full answer...

Answer 7

I am attaching a wiring diagram for the Replacement Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters #AT91959 that you can reference.

view full answer...

Answer 8

There's a wiring diagram in the install instructions for the Dometic RV Water Heater part #DMC74FR that I attached to this page. I don't have a way to verify what the wires of your RV are that ran to your old water heater though. We do have…

view full answer...

Answer 9

Yes. you can use the Single-Panel On/Off Switch for Atwood Gas and Electric Water Heaters #AT91859 with your Atwood MPD 93756 water heater. We have this switch available in black if you're interested #AT91959.

view full answer...

Answer 10

The manual for the Double-Panel On/Off Switch for Dometic Gas / Electric Combination Water Heaters - White #AT91230 lists the wire as orange but the manual for Atwood water heaters like AT94022 list the wire as red. It's referring to the wires…

view full answer...

Answer 11

I attached a diagram that shows how the Atwood switch part #AT91959 wires up. There are three sets of wiring diagrams that you will need to compare to the water heater you have now to determine which is correct.

view full answer...

Answer 12

You will want to check for power going into your Wall Controller #FR48NR by removing it from the wall and testing the wires with a Circuit Tester #PTW2992 that shows you battery voltage or by using a Multimeter #PT89ZR. Both wires will be blue and…

view full answer...

Replacement for Atwood Water Heater Switch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching