Recommended Suspension Components for 2014 Flagstaff MAC 206 LTD Camper

Question

Question:

Hello, I have a 2014 Flagstaff MAC 206 LTD Camper. I would like to replace the leaf springs and hardware as one is bent. I would like to replace both sides. What do you recommend? The specs on the label on the side of the trailer are as follows: GVWR/PNBV 1031 2274 LB Front 953KG, 2100 LB I would also like to replace the tires: ST145/R12/E Can you quote me what all I need? Thanks

asked by: Joe D

0

Expert Reply:

To help you with the replacement parts you need, you will need to measure your springs from eye to eye. We have the 3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 20-3/8" Long # e84SR, the 4-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 26" Long # e77SR, or the 3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 23-1/2" Long # SP-113275.

If you are replacing one hanger, then you will need to know the dimensions. I have attached the link to your options.

If you are replacing all the hangers and the suspension, then I recommend the Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear # APS4 along with the leaf springs # SP-169275. I've attached the dimensions needed and an article on axle positioning to assist.

For your replacement tires, I recommend the Kenda Karrier S-Trail ST145/R12 Radial Trailer Tire - Load Range E # AM10140.

expert reply by: Jason S

0

click to enlarge

Answer 1

With the 4-Leaf Double-Eye Spring - 26" Long #e77SR having an axle capacity of 2,000 pounds, each spring is actually only rated to 1,000 pounds. These technically can be used, but you will most likely bottom out when driving under load.…

view full answer...

Answer 2

Front and rear suspension hangers are not often the same height like this but they can be. If you have the hanger spacing right then what will happen is the center of the spring will be offset a little between the two hangers to compensate some for…

view full answer...

Answer 3

I do have an option for you but the lift block kits you're referencing are for torsion axles and won't work for leaf spring axles. Instead, I recommend the Correct Track Trailer Alignment and Lift Kit part #LC87120 which will provide a…

view full answer...

Answer 4

A lot of people get hung up on how many layers their leaf springs have but that actually isn't crucial at all. To choose the correct replacement leaf springs for your trailer you simply need to pick one that has a weight capacity that is rated…

view full answer...

Answer 5

The Curt Adjustable Width Trailer Hitch Receiver for RVs #13703 uses frame brackets for installation, and those need to be positioned on the inside of an I-beam frame, as per the instructions (a copy of which I have linked for you). That is what will…

view full answer...

Answer 6

The B&W Companion OEM 5th Wheel Trailer Hitch #BWRVK3700 is perfectly compatible with cushioned pin boxes like your MORryde RP072-1621HD, so the clunking you're experiencing isn't related to the two components being incompatible. With…

view full answer...

Answer 7

It's totally normal for a bit of movement between any fifth wheel hitch and the base rails. The feet on the hitch are typically a bit smaller than the slots they slide into for mounting otherwise you'd have a hard time getting your hitch in…

view full answer...

Answer 8

There is not a fuse we carry for the 8000 Series of Fan-Tastic vent. It does use a 4 amp slow blow fuse so to make fuse access simpler you can use In-Line Fuse Holder #C58470-1 and if you need to replace the bow-tie bracket, motor, and blade the…

view full answer...

Answer 9

view full answer...

Answer 10

The only difference between 7-Way Utility and 7-Way RV is the color of the wires. The pin outs are the exact same so either would work just fine with the other. If you check out the picture I attached you'll see that the functions are all the…

view full answer...

Answer 11

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Recommended Suspension Components for 2014 Flagstaff MAC 206 LTD Camper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching