Dimensions for Buyers Product Wiring Junction Box # 3375601101

Question

Question:

What are the dimensions of this item? Just box dimensions not including mounting tabs.

asked by: Dan

0

Expert Reply:

The Buyers Products Trailer Wiring Junction Box # 3375601101 referenced in your question measures 6.5 inches long, 3.21 inches wide, and 2.5 inches tall when the cover is installed. The mounting holes at each end are spaced apart 7.38 inches on center.

I have attached an image to assist.

expert reply by: Chris R

0

click to enlarge

Answer 1

The size of the nuts that fit the posts of the Trailer Wiring Junction Box #3375601101 is M5-.8 pitch. This does not come with extra nuts.

view full answer...

Answer 2

The Tru Ryde grease seals you mentioned, part #RG06-70 are indeed a replacement for the 10-036-00 Dexter seals. They would work great for your application.

view full answer...

Answer 3

Those are the wires for the brake magnets. You will need to connect the black wire to the brake controller output wire on your trailer connector and you are correct the white wire will need to be grounded to a clean metal surface on the trailer. I…

view full answer...

Answer 4

The wiring on your trailer is correct. The Breakaway Switch #C52010 does get wired directly to the battery without a fuse or circuit breaker. This ensures that in the event the trailer becomes disconnected the brakes activate. A circuit breaker…

view full answer...

Answer 5

If the pin on the breakaway switch is pulled or broken then yes you should have 12 volts entering and exiting the switch as this is what will engage the brakes on the trailer. The breakaway switch on your trailer is a normally open circuit which…

view full answer...

Answer 6

The Electric Trailer Brake Kit part #AKEBRK-35-SA has a self adjusting mechanism which means that you do not need to adjust the brakes for even pad wear after the initial setup. The Dexter Nev-R-Adjust Electric Trailer Brake Kit part #23-468-469…

view full answer...

Answer 7

The ring terminal size you need for the posts of the junction box part #3375601101 that you referenced is 3/16 inch like the part #44-5310A which would work great. The terminal matches the correct ring size and also is designed for 10 to 12 gauge…

view full answer...

Answer 8

What you can do is apply something like Liquid Electrical Tape, #SWC50122, which will insulate, seal, and waterproof electrical connections. I would still recommend wrapping any connections with actual electrical tape as well for extra protection.…

view full answer...

Answer 9

It's a wire color difference but not a function difference on the pins of the 7-way. The difference comes from the fact that the two different styles are representative of two different areas that uses trailers. Traditional is usually seen…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

Connection three 10-gauge wires together is going to be best accomplished by soldering the connections as this is the most secure method. We have a solder gun that comes with solder as well with part #PTW2012. I realize that not everyone knows how…

view full answer...

Answer 12

You have a good plan! You are correct that once you have a functional 7-way connector and the Tekonsha Prodigy P3 #90195 installed in your truck that you will not need any other wiring on the truck. Going with a junction box like the #38656 to…

view full answer...

Dimensions for Buyers Product Wiring Junction Box # 3375601101

Product Page this Question was Asked From

Continue Researching