Capacity of Gen-Y 2-Tang Clevis for 2-1/2" Hitch Receivers

Question

Question:

What is the tow weight for this hitch. Is it 2 1/2 inches between the tangs.

asked by: Ric C

0

Expert Reply:

I went to the warehouse to measure the Gen-Y 2-Tang Clevis # 325-GH-069 and can confirm it is 2-1/2" between the tangs. I also reached out to a representative of Gen-Y who said that the towing capacity is 21,000 lbs.

expert reply by: Kyle S

0

click to enlarge

Answer 1

I have a solution for you, but the part number AMCC2HD has been discontinued so your best option would be to get the #AMCC2 that you referenced and then use the Curt adapter part #C45405 to adapt it to fit a 2-1/2 inch hitch.

view full answer...

Answer 2

If your truck has a 2" hitch receiver and you want to make connections with a 1" clevis pin then you can use the MaxxTow #MT70034 two-tang clevis rated for 5,000 pounds. If you need more capacity you could use the Convert-A-Ball #AMCC2…

view full answer...

Answer 3

The distance between the tangs on Convert-A-Ball Cushioned Ball Mount/Clevis/Pintle #AMCC2 is 2 inches. I've attached a link to a video review of this product for you to take a look at.

view full answer...

Answer 4

Definitely! The distance between the tangs on the Gen-Y Clevis #325-GH-039 is exactly 1.95" when measured with calipers. I went ahead and attached a diagram of this measurement for your convenience. For a hitch pin to secure the clevis to your…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 7

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 8

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 9

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 10

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 11

The Trailer Leaf Spring, 2250 lbs. 6 Leaf, item #e27SR, is sold as a replacement spring for older trailers and measures 26 inches for eye to eye, center to center. If you are replacing the springs and hangers you will need to use the same center to…

view full answer...

Answer 12

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Capacity of Gen-Y 2-Tang Clevis for 2-1/2" Hitch Receivers

Product Page this Question was Asked From

Continue Researching