What Size Socket is Needed to Install Draw Tite Trailer Hitch on 2015 Nissan Rogue
Question:
For a 2015 nissan rouge, what size sockets are needed for the removal of the tow hook and the installation of the hitch?
asked by: Ted
0
Expert Reply:
According to the linked directions you will need 18mm and 19mm sockets to install the Draw-Tite Max-Frame Trailer Hitch Receiver # 75902 on your 2015 Nissan Rogue.
The 18mm socket is what is needed to remove the bolts that are securing the factory tow hook while the 19mm socket is what is used to tighten down the hardware for the hitch.
expert reply by:
Kyle S
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Availability Of Curt Trailer Hitch For A 2024 Hyundai Santa Fe Hybrid
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Add a 7-Way Connector for a 2023 Ford Bronco w/out the Factory Towing Package
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: 7-Way For 2023 Ford F-150 That Has 4-Way Connector
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Is Lock Needed for Lower Hitch Opening of EcoHitch Stealth Hitch
- Article: Trailer Wiring Diagrams
- Article: How to Install a Trailer Hitch
- Q&A: Recommended Trailer Hitch for 2017 Nissan Rogue
- Article: How to Measure a Trailer Axle
- Q&A: Aero Bar Roof Rack that Fits 2022 Toyota Highlander