Installing 7-Way and 4-Way Connectors on a 2015 GMC Acadia
Question:
I have a wiring harness pre installed. And ordered a HM40975. Jon G suggested part 118271 to connect the 2. My question is, will part #118271 run the 7 pole and the 4 flat on part HM40975? Or just the 7 pole? Thank you.
asked by: Nathan S
Helpful Expert Reply:
The Hopkins # HM40975 that you referenced plugs into a US Car Connector (see attached picture). This typically will replace a factory 7-Way on a vehicle so if your 2015 GMC Acadia didn't come with a 7-Way you might not have that connector. If it does exist though it will be located somewhere around the trailer hitch.
If you don't have the US Car Connector but you would like fully functioning 7-Way and 4-Way connectors then we do have a solution for you. Simpy install the T-One Vehicle Wiring Harness # 118271 (if you have the factory tow package) and then swap out the included connector with the Hopkins # HM40975 that you referenced. To keep from drilling into your vehicle or trailer hitch use the No-Drill Mount Bracket # 18140 as well.
Attached are some installation videos for you to check out.
Products Referenced in This Question
T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Tekonsha
more information >
No-Drill Mount for Electrical Mounting Bracket - Short
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 4 Flat
- 5 Flat
- 4 Round
- 5 Round
- Tow Ready
more information >
Product Page this Question was Asked From
7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure for Trailer Hitch Drop
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Availability Of Hub/Drum Kit With Brakes And Hardware Similar To Part BPH1206EPR
- Q&A: Parts Needed To Add a Tow Package To a 2024 GMC Canyon
- Q&A: Gooseneck Trailer Hitch for a 1996 Ford F-450
- Q&A: How Does the Hopkins 7-Way part # HM40975 Wire to a Vehicle
- Q&A: Recommended Blue Ox Flat Towing Components For A 2020 Jeep Grand Cherokee Trailhawk
Nathan S.
6/7/2018
I have a wiring harness pre installed. And ordered a HM40975. Jon G suggested part 118271 to connect the 2. My question is, will part #118271 run the 7 pole and the 4 flat on part HM40975? Or just the 7 pole? Thank you.