Does Replacement Fastway e2 L-Pin # FA92-03-9205 Fit 12k Rated Fastway e2 Kit

Question

Question:

Are there different sizes of the L-Pin for the different weight classes? if so what L-Pin would work for the 12,000 pond system

asked by: Roy S

0

Expert Reply:

The replacement L-pin part # FA92-03-9205 that you referenced fits Fastway e2 kits that are 6,000-lb, 8,000-lb, 10,000-lb, or 12,000-lb.

expert reply by: Jameson C

0

Answer 1

I was able to go out to the warehouse and measure the Replacement L-Pin for Fastway e2 Weight Distribution Systems #FA92-03-9205 for you. I found that the square stock is 5/8 inch by 5/8 inch. The measurement from the pin hole to the bend is 1.64…

view full answer...

Answer 2

I would be happy to help! The correct L-Pin clip for the Replacement L-Pin for Fastway e2 Weight Distribution Systems #FA92-03-9205 you were looking at is the Replacement L-Pin Clip for Fastway e2 Weight Distribution Systems #FA92-04-9208. I included…

view full answer...

Answer 3

Thank you for all of the info. I went out to the warehouse and found that from the back side of the face of the lock to the arm it did indeed measure about 5/8" as you can see in the attached photo. The Camco Cam Lock #CAM44340 comes with both a…

view full answer...

Answer 4

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 9

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

view full answer...

Answer 10

According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…

view full answer...

Does Replacement Fastway e2 L-Pin # FA92-03-9205 Fit 12k Rated Fastway e2 Kit

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching