Recommended Wiring and Brake Controller for 2001 Nissan Xterra with Factory 7-Way
Question:
Hi there, I have a 2001 Nissan xTerra with a factory trailer connector. Id like to install a brake controller, but cant seem to find any specific instructions on how to do so. Can you help direct me to the right parts and ideally instructions? Thanks!
asked by: Simon W
Expert Reply:
We don't have any manufacturers that make a brake controller harness for your 2001 Nissan Xterra with factory trailer connector. You will need to use the wiring kit # 5506 to hardwire your controller. This will not hurt your current connection, it will simply give you the wiring from the battery to your brake controller with the proper 30 amp circuit breaker in line and then your brake controller output will either splice into your factory run brake output wire or replace it running straight back to your 5 o'clock pin. This will be a very similar installation to the # ETBC7 which I've attached an article and video of to assist.
For your brake controller if you don't already have one, I recommend the Prodigy P3 # 90195. I've attached some videos of this controller and the fit on your 2001 Nissan Xterra.
Products Referenced in This Question
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Replacement Parts for Fan-Tastic Vent 8000 Series