How to Adjust Drum Brake Pad Pressure Using Brake Spoon Tool
Question:
I have a 2015 Cougar 28foot with 12x2inch brakes controlled with the Prodigy 2 controller. I cant get to trailer brakes to get close to a lock up, just a soft drag and not enough to be any useful breaking. Using the manual lever on the Prodigy controller I set it on 6.2 Tested the trucks bumper plug and get 6.5. Ok to that point! But when I test voltage on the trailer at its junction box I get 4.9. I disconnected the brake wire at the first brake and after separating this wire from the brakes Im back to 6.5. That just confirmed I did not have a bad wire to that point. So Question.. Do the electric brakes have a natural voltage when all wires connected or may I have a magnet with stray voltage. Im reluctant on buying 4 new brakes before I know why the soft brake problem. I serviced the bearings this week and there is little wear on the brakes. Thanks for any help or advice.
asked by: Mike M
Expert Reply:
If you have not already done so you can adjust the brake pad pressure star wheel to increase the pad pressure on the hub surface. This will increase your braking force. Since it sounds like all the brakes are behaving in the same way (and have the same modest wear) this is most likely the issue.
You can use the brake spoon adjustment tool # W80630 or a flat blade screwdriver to rotate the star wheel upward (as viewed from the rear of the brake, where the adjustment slot is). Please refer to the linked videos for the brake spoon tool to see the adjustment wheel and how to access it.
Products Referenced in This Question
Brake Adjustment Spoon for Drum Brakes
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- Adjuster
- Brake Adjuster Tool
- Performance Tool
more information >
Product Page this Question was Asked From
etrailer Electric Trailer Brakes - Self-Adjusting - 12" - Left/Right Hand - 5.2K to 7K
- Trailer Brakes
- Electric Drum Brakes
- Standard Grade
- Self Adjust
- 12 x 2 Inch Drum
- 5200 lbs Axle
- 6000 lbs Axle
- 7000 lbs Axle
- 14-1/2 Inch Wheel
- 15 Inch Wheel
- 16 Inch Wheel
- etrailer
more information >
Continue Researching
- Q&A: Comparing Uni-Servo and Free Backing Hydraulic Drum Trailer Brakes
- Q&A: Difference Between Single, Dual and Free Backing Servo Brake Assemblies
- Shop: Demco Hydraulic Drum Brake - Single Servo - Galvanized - 10" - LH - Self-Adjusting - 3,500 lbs
- Shop: Brake Adjustment Spoon for Drum Brakes
- Video: etrailer Left and Right Hand Hydraulic Brake Kit Installation
- Video: Review of Bright Way Trailer Breakaway Kit - 3802348
- Shop: Electric Trailer Brake with Dust Shield - Self-Adjusting - 12-1/4" - Right Hand - 10,000 lbs
- Shop: Dexstar Dual Wheel with Offset - 16 x 6 Rim - 8 on 6.5
- Shop: Replacement Breakaway Switch for Bright Way Trailer Breakaway Kits
- Search Results: trailer brakes
- Search Results: trailer battery box
- Search Results: akebrk~10r
- Search Results: brake spoon
- Q&A: Recommended Replacement Drum Brakes for Boat Trailer with 3500-lbs Axles
- Q&A: For Trailer Brake Assemblies Which Side of the Trailer Is Left Hand Side and Right Hand Side
- Q&A: Proper Way to Adjust Brake Assemblies of Hydraulic Brake Kit # AKFBBRK-35-D
- Q&A: Comparing Dacromet Hydraulic Trailer Brake Assemblies for 10 Inch Hubs
- Q&A: Compatability of Hydraulic Brake Kit AKFBBRK-35-D and Hub and Drum Assembly AKHD-545-35-EZ-K
- Shop: Hydraulic Brake Kit - Uni-Servo - Free Backing - Dacromet - 10" - Left/Right Hand - 3,500 lbs
- Shop: Mounting Hardware for 10" Brake Assemblies
- Shop: Trailer Hitch
- Article: Trailer Tire Sizing
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Search Results: 25580
- Video: etrailer Electric Trailer Brake Kit Installation
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Brake Controller
- Search Results: 68149