Where Do I Look If I Can't Find the VIN on a 1997 Doo Little 20 Foot Trailer?
Question:
Can not fine vin on a 97 doo little 20ft on trailer
asked by: Richard R
Expert Reply:
Usually brand name trailer manufacturers will indicate the unique vehicle identification number (VIN) on the same plaque that carries their brand name, model number information and the trailer specifications.
If you cannot find the VIN on the trailer tongue you can check for plaques on other parts of the trailer. It may even be stamped into the frame. Perhaps you can find some helping hands to assist you in moving the trailer around to check its underside (especially near the axle and on the primary frame members) for any additional markings or labels.
It could be that the original owner did not register the trailer due to the absence of the VIN number. If the model number information you found was on the trailer coupler, rather than on the trailer frame itself, it may be that the coupler was commercially manufactured and added to the trailer at a later date as a replacement part.
In cases of trailers that have no VIN which can be fairly common, your local state police or highway patrol can assign a VIN number for you.
Product Page this Question was Asked From
A-Frame Trailer Coupler - Yoke Latch - Black - 2" Ball - Weld On - 8,000 lbs
- A-Frame Trailer Coupler
- Standard Coupler
- Weld-On
- 8000 lbs GTW
- 2 Inch Ball Coupler
- Yoke Latch
- etrailer
more information >
Continue Researching
- Shop: A-Frame Trailer Coupler - Yoke Latch - Black - 2" Ball - Weld On - 8,000 lbs
- Q&A: A-Frame Coupler Replacement Needed for a 2008 Fleetwood Bayside Popup Camper
- Shop: Demco Cast Head Coupler w/ Jack Hole - eZ-Latch - 2" Ball - A-Frame - Bolt-On - 10K
- Shop: A-Frame Coupler with Black Paint Finish - 2" Ball - 5,000 lbs
- Video: Review of Demco A-Frame Trailer Coupler - Standard Coupler - DM14791-97
- Q&A: How to Measure the Angle of Trailer A Frame To Determine if a 50 Degree A Frame Coupler will Fit
- Q&A: Mounting Hardware Needed for 10K Demco Cast Head Coupler eZ Latch
- Shop: Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Primed - 2" Ball - Weld On - 10K
- Search Results: a~frame coupler
- Shop: Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - Black - 2" Ball - Bolt On - 10K
- Search Results: trailer coupler
- Search Results: tounge
- Search Results: 2 inch coupler
- Search Results: coupler
- Video: Review of etrailer 4 Leaf Double Eye Spring - e77SR
- Search Results: 1000 lb leaf springs
- Search Results: tongue
- Shop: 4-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 26" Long
- Shop: Channel Tongue Trailer Coupler - Trigger Latch - Zinc - 2" Ball - Bolt On - 3,500 lbs
- Video: etrailer A-Frame Trailer Coupler - Standard Coupler - CA-5210-B Review
- Q&A: What Is The Angle For The etrailer A-Frame Trailer Coupler?
- Q&A: Replacement Yoke Latch for Heartland Trailer with 8,000 Lb Coupler
- Video: Demco Composite eZ-Latch Repair Kit Review DM6008
- Q&A: Width of A-Frame Trailer Coupler CA-5210-B
- Video: etrailer A-Frame Trailer Coupler - Standard Coupler - CA5100B Review
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Shop: Trailer Wiring