What Size Diameter Hole Is Needed to Install Optronics Trailer Light # MCL50AB
Question:
What size hole is needed to install these lights.Part number MCL50AB Thank You
asked by: Clarence P
Expert Reply:
To install the Optronics Trailer Light, part # MCL50AB, you will need to use 2 Inch Round Grommet, part # A54GB. The mounting hole to properly install the light # MCL50AB with the grommet should be 2-5/16 inches in diameter.
This light uses a 2-wire plug, like the Two Wire Pigtail, part # A46PB.
The Optronics Trailer Light # MCL50AB is a sealed, waterproof LED light. The advantage of an LED light is that it burns brighter than an incandescent light but draw less power. It is also great for marine applications since it is waterproof.
Products Referenced in This Question
Right Angle 2-Wire Pigtail for Optronics Trailer Lights - 2-Prong PL-10 Plug - 6" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 6 Inch Long
- Two Wire
- Right Angle Pigtail
- Optronics
more information >
2" Round Grommet - Flush Mount - Open Back
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- 2 Inch Diameter
- Grommet
- Round
- Optronics
more information >
Product Page this Question was Asked From
Miro-Flex LED Clearance or Side Marker Light w/ Reflector - Submersible - 9 Diodes - Amber Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 2 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Recommended Replacement For A Greystone 26 RV Fireplace # F2625
- Q&A: Parts List to Re-Wire a Trailer w/ Electric Brakes
- Article: Troubleshooting Brake Controller Installations
- Q&A: USA Made Bearing Kit For An AL-KO 4,400 lb Axle
- Q&A: Installation of Firestone Red Label Air Bags on 2012 Ford F-250 With Block Underneath Jounce Stop
- Q&A: Recommended Amber Clearance Light To Replace Glo-Brite 9500-88
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Are the Torque Specs for Trailer Suspension Parts
- Q&A: Location of the 40-Amp Fuse for the 2006 Chevrolet Silverado Tow Package
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Wiring Diagrams