LED Stop Turn and Tail Signal Lighting for a Motorcycle Pull Behind Trailer
Question:
Can the two blinkers be connected to this light using a split diode [2 into 1] wire and connect to the turn wire or will I need to run 2 lights to get separate blinkers Motorcycle pull behind trailer
asked by: Dennis H
Expert Reply:
To meet DOT standards you will need to have both a left side and right side blinker on your motorcycle trailer. The LED Stop/Turn/Tail Light, item # STL69RRXB, is not separated so that the left side of the light and right side of the light can blink separately, so you will need two of these lights to complete your lighting setup.
I have seen many motorcycle trailers with two of the Sealed, 6-1/2 inch Oval, LED Trailer lights, item # STL22RB, mounted next to each other at the back of the trailer, using 2 rubber grommets, item # a70gb, and 2 pigtails, item # A45PB.
At this time we do not carry a diode that is recommended for the application you are suggesting.
Products Referenced in This Question
3-Wire Pigtail for Optronics Trailer Lights - 3-Prong PL-3 Plug - 10" Lead
- Accessories and Parts
- Trailer Lights
- Wiring
- Plugs and Pigtails
- 10 Inch Long
- Three Wire
- Straight Pigtail
- Optronics
more information >
PVC Grommet for 6-1/2" Oval Trailer Tail Lights
- Accessories and Parts
- Trailer Lights
- Mounting Hardware
- Grommet
- 6-1/2 Inch Long
- Oval
- Optronics
more information >
Miro-Flex LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 12 Diodes - Oval - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2-5/16W Inch
- Red
- Optronics
more information >
Product Page this Question was Asked From
Thinline LED Trailer Tail Light w/ Reflector - Stop, Tail, Turn - Submersible - 11 Diodes - Red Lens
- Trailer Lights
- Tail Lights
- Rear Reflector
- Stop/Turn/Tail
- Oval
- Surface Mount
- Submersible Lights
- LED Light
- 15L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Shop: Hopkins Endurance 5-Way Flat Trailer Connector - Trailer End - Ergonomic Design
- Article: Trailer Wiring Diagrams
- Shop: Curt Auxiliary LED Indicator Lights
- Shop: Hopkins Endurance 5-Way Flat Trailer Connector - Vehicle End - Ergonomic Design
- Video: Optronics Trailer Lights - Tail Lights - STL69RRXB Review
- Shop: Thinline LED Trailer Tail Light w/ Reflector - Stop, Tail, Turn - Submersible - 11 Diodes - Red Lens
- Video: Optronics Trailer Lights - Tail Lights - STL59RB Review
- Shop: Thinline LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 9 Diodes - Red Lens
- Shop: Grease Seals 10-36 (pair)
- Video: Choosing the Right Trailer Wiring
- Search Results: 44649
- Shop: Trailer Hitch
- Q&A: How to Determine if Trailer Axle is Not Aligned and How to Measure to Replace Trailer Axle
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Optronics LED Trailer Tail Light - Stop, Tail, Turn - Submersible - 10 Diodes - Red Lens
- Shop: Trailer Wiring
- Video: Choosing the Right Brake Controller
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Search Results: 68149
- Shop: Brake Controller
- Search Results: 25580
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How to Tell If MORryde Rubber Equalizers Will Fit Trailer
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: Fifth Wheel Hitch
- Article: Trailer Tire Sizing
- Video: Timbren Axle-Less Trailer Suspension System Installation
- Search Results: dust cap
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Suspension Enhancement
on Trailer Lights
