Is Trimming Required for Installation of the 2008 Volkswagen Rabbit Hitch # 11074
Question:
Does this hitch require trimming of the bumper?
asked by: David
Expert Reply:
No, installation of the Curt Class I Trailer Hitch, item # 11074, on a 2008 Volkswagen Rabbit does not require trimming of the rear bumper fascia. I have included a link to the installation instructions for you to review.
To complete your Class I Towing setup you may also want to consider the following items.
Vehicle Wiring # 119250KIT
1-7/8 inch hitch ball # 19256
2 inch hitch ball # 19258
Pin and clip # PC2
Products Referenced in This Question
ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- Tekonsha
more information >
1-7/8" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
2" Hitch Ball - 3/4" Diameter x 1-9/16" Long Shank - Chrome - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 1-9/16 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- Draw-Tite
more information >
Pin and Clip for 1-1/4" Hitches - 1/2" Diameter
- Hitch Pins and Clips
- Standard Hitch Pin
- Fits 1-1/4 Inch Hitch
- 1/2 Inch Diameter
- Draw-Tite
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
- Article: Trailer Wiring Diagrams
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between Class 1 and Class 2 Hitches for the Scion XB
- Q&A: How to Prevent Exhaust Components from Contacting the Trailer Hitch
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: How To Order Replacement Hardware Kit For Curt Trailer Hitch
- Article: How to Install a Trailer Hitch
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Replacement for Atwood GCH6A-10E RV Water Heater
- Q&A: Troubleshooting and Fuse Location on Furrion Over the Range RV Convection Microwave
- Article: Trailer Hitch Installation Tips
- Article: What Do I Need To Tow A Trailer?
- Article: Roof-Mounted Watersport Carriers