How Far Down Does Tow-Rax Wall Mounted Folding Table Hang when Folded Down

Question

Question:

I understand that it measures 18.5 wide, is that also how far down the wall it will hang in the lowered position? Or, does it have a pivot point that allows it a shallower hang measurement? I have an outlet that Im trying to avoid while maintaining a 36inch counter height to match the other counters that are in the trailer.

asked by: Brant

0

Expert Reply:

When hanging down the Tow-Rax Wall Mounted Folding Table - Aluminum, Item # TWSP45HFTA, will take up 18-1/2 inches of vertical space on the wall. The pivot point is approximately 1 inch down from the top of the table.

You could also add Mounting Buttons for Tow-Rax Wall Mounted Folding Table - Aluminum - 3 mm Item # TWSP30BK. They will allow you to easily mount and remove your Tow-Rax folding table.

expert reply by: Michael H

0

Answer 1

The Tow-Rax Wall Mounted Folding Table #TWSP45HFTA includes the L-shaped support struts that hold the table in place and allow it to fold down when not in use. You can either do a permanent installation with fasteners you source locally or you can…

view full answer...

Answer 2

The Tow-Rax folding table #TWSP45HFTA is made of aluminum and has aluminum hardware which is not likely to start rusting so salt water would not be a problem. But I would still rinse it off with fresh water when possible to ensure the longest life.

view full answer...

Answer 3

The Tow-Rax Wall Mounted Aluminum Folding Table #TWSP45HFTA does not lock in the folded position. I confirmed this with my contact at Tow-Rax. It does lock in the up position. If you want to have the folded table top secure during travel we offer…

view full answer...

Answer 4

The actual weight capacity of the Tow-Rax Wall Mounted Folding Table #TWSP45HFTA is indeed 100-lbs maximum. If you install the table on 1/2-inch plywood with the mounting screws going into wall studs you should be able to realize the table's full…

view full answer...

Answer 5

I spoke with my contact over at Tow-Rax and the wall-mounted folding table has a working load capacity of 100 pounds. I have linked the video review of this table for you as well.

view full answer...

Answer 6

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

Yes, you will need the Thule universal change key, #853-1251, to remove and install new lock cores. the change key pulls down all the tumblers so the lock can be removed or inserted. The existing lock, if present, will have to be unlocked for the…

view full answer...

Answer 9

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

view full answer...

How Far Down Does Tow-Rax Wall Mounted Folding Table Hang when Folded Down

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching