What is Actual Weight Capacity of Tow-Rax Wall Mounted Folding Table # TWSP45HFTA

Question

Question:

In your Q and A section that is along side of this text box for part #twsp45hfta one of the questioned asked is What is weight capacity of this folding table in the upright positioninch The question is answered by your Adam R. who states the weight capacity of the table is 100 lbs.. BUT..... when I go to your website and read the description, it states in 2 different places that the weight capacity of the table is 250 lbs. That is a huge difference. Can you please confirm what the true and accurate weight capacity is. I suspect is it a direct relation to how strong the wall is and the fasteners you are using to attach the wall brackets. For this question please assume I am using the fasteners that come with the unit and I am attaching to a 1/2inch plywood wall as show in your video. Thank You.

asked by: Rick K

0

Expert Reply:

The actual weight capacity of the Tow-Rax Wall Mounted Folding Table # TWSP45HFTA is indeed 100-lbs maximum.

If you install the table on 1/2-inch plywood with the mounting screws going into wall studs you should be able to realize the table's full 100-lb capacity. You are correct that how/where you mount the table will affect capacity to an extent but in no circumstances will any installation offer more than 100-lbs total weight bearing capability.

expert reply by: Adam R

0

Answer 1

The Tow-Rax folding table #TWSP45HFTA is made of aluminum and has aluminum hardware which is not likely to start rusting so salt water would not be a problem. But I would still rinse it off with fresh water when possible to ensure the longest life.

view full answer...

Answer 2

When hanging down the Tow-Rax Wall Mounted Folding Table - Aluminum, Item #TWSP45HFTA, will take up 18-1/2 inches of vertical space on the wall. The pivot point is approximately 1 inch down from the top of the table. You could also add Mounting…

view full answer...

Answer 3

The Tow-Rax Wall Mounted Folding Table #TWSP45HFTA includes the L-shaped support struts that hold the table in place and allow it to fold down when not in use. You can either do a permanent installation with fasteners you source locally or you can…

view full answer...

Answer 4

The Tow-Rax Wall Mounted Aluminum Folding Table #TWSP45HFTA does not lock in the folded position. I confirmed this with my contact at Tow-Rax. It does lock in the up position. If you want to have the folded table top secure during travel we offer…

view full answer...

Answer 5

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

Yes, you will need the Thule universal change key, #853-1251, to remove and install new lock cores. the change key pulls down all the tumblers so the lock can be removed or inserted. The existing lock, if present, will have to be unlocked for the…

view full answer...

Answer 8

There should be 2 inches minimum between the tires on a dual axle trailer. This will allow the suspension components room to work properly but a little more room is ideal. For instance the Ultra-Fab Chock and Lock Wheel Stabilizers for Tandem-Axle…

view full answer...

What is Actual Weight Capacity of Tow-Rax Wall Mounted Folding Table # TWSP45HFTA

Product Page this Question was Asked From

Continue Researching