Underbed 5th Wheel Rail Mounting Systems for a 2017 Ford F-350 4WD With an 8 Foot Bed

Question

Question:

Is the 5th wheel underbed rail mounting system offered for a 2017 F350 4WD with an 8 foot bed. I see where it was for earlier F350s. I am wanting the 27k Reese with the single latching jaw. Thanks

asked by: Steve

0

Expert Reply:

Yes, we do have some underbed mounting systems for your 2017 Ford F-350, but unfortunately there are no Reese 5th wheel hitch options rated for 26K. The only Reese hitch that fit with their Under-Bed Rail and Installation Kit # RP30126 was the Reese M5 20K # RP30921. Neither of which are a fit for your F-350.

If you were wanting to stick with the below bed rails we have an option from B&W which is their Underbed Gooseneck Hitch # BWGNRK1116-5W along with the Companion # BWRVK3500-5W which is rated for 20K. The great advantage of this heavy-duty combination is that you can pull pull a gooseneck trailer if the need arises.

The other option would be to go with the Demco Underbed Rails # DM8551009 along with the Hijacker 5th Wheel Hitch # DM8550032. The Hijacker is rated for 21K and not only uses the single jaw design that you were asking for, but it also has a 3/4 inch thick steel locking bar for added security for the king pin. The single jaw provides some of the best 360 degree king pin to jaw contact out there. This is honestly one of my favorite 5th wheel hitches out there because of this design.

If you would rather stick with the Reese M5 design that you referred to then we do have that option rated at 27K but it will require that bed rails be installed above your bed instead of below it. For this setup you will need the Base Rails # RP50074-58 and the Reese M5 # RP46FR.

I also recommend installing a 7-Way connector, like part # C56000, in the bed of your truck for an easier connect and disconnect of the wiring on your trailer.

I have attached some review and installation videos on these products for you to check out as well.

expert reply by: Jon G

0

Answer 1

I spoke with my Curt representative, who tells me that either Grade 8 or Grade 5 half-inch bolts are acceptable. In the past, they provided Grade 5 with their install kits, but recently changed to Grade 8. It doesn't matter which of the two bolts…

view full answer...

Answer 2

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 3

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 4

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 5

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 6

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 7

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 8

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine, as…

view full answer...

Answer 9

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

I checked with Curt and they do show the Curt Trailer Hitch Receiver part #C13233 as a fit for a 2022 Volvo XC90 All Models which includes the Recharge.

view full answer...

Answer 12

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Underbed 5th Wheel Rail Mounting Systems for a 2017 Ford F-350 4WD With an 8 Foot Bed

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching