Will The Ultra-Fab Dirt Bike Carrier Part # UF48-979033 Clear The Spare Tire On A Jeep Wrangler
Question:
I recently purchased #MT70101 Max Tow MaxxHaul Motorcycle Carrier for a Honda CRF150FH Dirt Bike. I have attached photos. The anti racket device does not fit. Should I purchase #Anti-Tilt-REV & will that help stabilize the carrier.
asked by: Stephanie M
Expert Reply:
The distance from the center of the hitch pin hole to the outermost part of the rear spare tire will vary depending on the hitch receiver installed. Assuming you have a stock tire and wheel size, the distance from the center of the hitch pin hole to the outermost portion of the spare tire is 11" while using the Curt Trailer Hitch Receiver part # 13432.
The distance from the center of the hitch pin hole to the closest part of the Ultra-Fab Dirt Bike Carrier part # UF48-979033 is 5" therefore, none of these hitch receivers will allow you to mount this dirt bike carrier without removal of the spare tire.
However, the Maxxtow Motorcycle Carrier part # MT70101 will work as long as you abide by the weight limitations as the distance from the center of the hitch pin hole to the closest part of the carrier is 12-1/2".
In order to secure the dirt bike to the carrier, you will also need a set of straps such as the ProGrip Cam Buckle Straps part # 317-412080.
I have attached a review for each of these products for you.
Products Referenced in This Question
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- No Cross Tube
- CURT
more information >
ProGrip ME-01 Cam Buckle Tie-Down Straps - S-Hooks - 1" x 6' - 400 lbs - Qty 2
- Boat Tie Downs
- S-Hooks
- 2 Straps
- Manual
- 6 - 10 Feet Long
- Cam Buckle Strap
- 0 - 1 Inch Wide
- 501 - 850 lbs
- ProGrip
more information >
Anti-Rattle Trailer Hitch Receiver Lock for 2" Hitches - 3-1/2" Span
- Trailer Hitch Lock
- Universal Anti-Rattle Lock
- Keyed Unique
- Fits 2 Inch Hitch
- Spring-Loaded Pin
- 3-1/2 Inch Span
- Lets Go Aero
more information >
Ultra-Fab Dirt Bike Carrier for 2" Hitches - With Ramp - 77" Long - 500 lbs
- Hitch Cargo Carrier
- Motorcycle Carrier
- Fixed Carrier
- Heavy Duty
- Fits 2 Inch Hitch
- Class III
- Class IV
- Steel
- Ultra-Fab Products
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 4000 lbs WD GTW
- 2 Inch Hitch
- 400 lbs WD TW
- No Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: Comparing Equa-Flex and Road Armor Equalizers For 2000 Forest River WIldwood W/ 5200lb Axles
- Q&A: Can 12 Volt Battery Replace Two 6 Volt Batteries
- Q&A: Replacement 12 inch Brake Assemblies for Dexter 36-89 on Trailer
- Q&A: Replacement Electric Brakes for Dexter PR-FF SEC-FF 5.2KPR-GGSEC-GG 12X2XQ 36-89
- Q&A: Comparing Curt and Tekonsha Trailer Wiring Harness for 2018 Jeep Wrangler Unlimited
- Q&A: Is a Master Key Needed to Install or Remove a Thule Lock Cylinder
- Article: How to Rent an RV
- Article: What Exactly is Tongue Weight?
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Article: Electric Brake Controller Installation on Dodge Ram Trucks to 2012
- Article: My Trailer Hitch Doesn't Fit
Stephanie M.
7/3/2017
I recently purchased #MT70101 Max Tow MaxxHaul Motorcycle Carrier for a Honda CRF150FH Dirt Bike. I have attached photos. The anti racket device does not fit. Should I purchase #Anti-Tilt-REV & will that help stabilize the carrier.