Are the Races Pressed Into the Hub
Question:
Does the hub come with the races already press into the hub?
asked by: Brandon
1
Helpful Expert Reply:
Yes, the races come pressed in the hub. You will only have to insert and pack the bearings (check out part # L70025) and press in the grease seal. A hammer and a small block helps when tapping in the grease seal. We also have a 7-Piece installation set, part # PTW83020, that comes in handy if you do your own trailer maintenance.
expert reply by:
John H
1
![John H](https://images.etrailer.com/static/images/catg/people/428_tn.jpg)
Products Referenced in This Question
LubriMatic Deluxe Bearing Packer
- Lubricants Sealants Adhesives
- Greasing Tools
- Bearing Packer
- LubriMatic
more information >
7-Piece Installation Set for Bearings, Races, and Seals
- Accessories and Parts
- Trailer Bearings Races Seals Caps
- Tools
- Driver
- Performance Tool
more information >
Product Page this Question was Asked From
Trailer Idler Hub Assembly for 2,000-lb Axles - 5 on 4-1/2 - Galvanized
- Trailer Hubs and Drums
- Hub
- Standard
- L44649
- L44649
- For 2000 lbs Axles
- 1/2 Inch Stud
- 5 on 4-1/2 Inch
- 10 Inch Wheel
- 12 Inch Wheel
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: What Is the Difference Between a BTR and BT8 Spindle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Spare Tire Recommendation for a Dual Jet Ski Trailer with 205 x 65 x 10 Load Range E Tires
- Article: How to Measure a Trailer Axle
- Q&A: Troubleshooting Factory Trailer Wiring that has No Power
- Article: Trailer Tire Sizing
- Q&A: Replacement Hubs for 1997 FLOE Pro 100 Plus Snowmobile Trailer
- Q&A: How to Determine the Size of a Trailer Hub Assembly for Replacement
- Q&A: Recommended Grease Seal w/ a 1.25 ID and a 1.98 OD