Needing a Replacement Washers of the Snug Tite Lock on a Thule t2 916
Question:
Can you give me part #s for a bolt washers and clip for whatever I need to not spend $60 on a snug tite?
asked by: Phil G
0
Expert Reply:
The Thule Snug Tite Hitch Lock, # THSTL2, uses a 12 mm hole diameter flat washer and lock washer when installing to the Thule bike rack.
These parts can be found at any hardware store if you need to replace just the washers.
If the pin needs replaced, you will need part # 853-5917. This is the threaded bolt pin that connects the hitch stinger to your vehicle's hitch.
expert reply by:
Jared P
0
Product Page this Question was Asked From
Thule Snug Tite Hitch Lock and Anti-Rattle Device
- Trailer Hitch Lock
- Rack Specific Locks
- Keyed Alike
- Fits 1-1/4 and 2 Inch Hitch
- Fits 1-1/4 Inch Hitch
- Fits 2 Inch Hitch
- Threaded Pin
- For Thule Racks
- Thule
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: LCI Leveling System Troubleshooting
- Q&A: How to Reset Zero Point Calibration on Lippert Ground Control 3.0
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: Replacement Multi-Function LED Trailer Light for Glo-Brite 9852-88
- Q&A: What Is The Recommended Lug Nut Torque On 7,000lb Axles?
- Q&A: Front Door Lock Assembly Replacement for Keystone Montana 5th Wheel
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Maintenance Schedule
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Article: Rolling on a Budget: Top Wallet-Friendly Platform Bike Racks
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: How to Measure for Trailer Hitch Drop