Where is Height of Surco RV Ladder SP502L Measured

Question

Question:

When you say a rv ladder is 84-1/2 in. tall is that to the top of ladder or to top of camper roof?

asked by: Bill

1

Helpful Expert Reply:

The Surco RV Ladder part # SP502L is our 84-1/2 inch tall ladder and it's height measurement is measured from the very top of the ladder down to the very bottom.

I attached a picture that shows this dimension.

expert reply by: Jameson C

1

click to enlarge

Answer 1

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 2

Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The linked chart details the recommended torque for many combinations. Dexter Hub/Drum #84546UC3 has 1/2-inch studs and…

view full answer...

Answer 3

The direct replacement for your Atwood Gc6aa/10E water heater has been discontinued. I recommend the Atwood RV Water Heater Item #DMC74FR which only requires a 12-3/4" x 12-3/4" cutout. This is a standard gas and electric, 10,000 BTU water…

view full answer...

Answer 4

Yes it is; for a 6-gallon tanked RV water heater, there isn't a better option than the Dometic: - Dometic RV Water Heater - Gas and Electric #DMC74FR At 10,000 Btus, this water heater has a higher heating capacity than other units for better…

view full answer...

Answer 5

The black wire from the break away switch will connect to the blue wire from the break away box, as shown in the provided diagram. By 'brake wires' I'm assuming you're speaking of the wires connected to the brake magnets on your brake…

view full answer...

Answer 6

Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…

view full answer...

Answer 7

If you look at the brackets of the TorkLift HiddenPower Under-Vehicle Battery Mount #TLA7727 you'll see that the top hook goes much wider than the bottom one. There wouldn't be a frame dimension that this will work with since trailer frames…

view full answer...

Answer 8

The Repair Kit Fulton Wedge-Latch Cast Head Coupler, #F670801, is designed to fit the coupler #BD44125W0317 which does take a 2-5/16 inch ball.

view full answer...

Answer 9

The Furrion Single Zone Controller part #FACC12SA-BL does have a dip switch setup underneath the cover of it.

view full answer...

Answer 10

The 18.5x8.5-8 is actually an old tire size that is not used much anymore. The closest metric size to your existing tire would be 215/60-8. Your wheel most likely has a 5-on 4-1/4 inch bolt pattern (see link), you will want to make sure that the bolt…

view full answer...

Answer 11

Ultimately you do not need a converter as you can wire the tail lights on your 2022 Ford F-150 to operate as brake and turn signals just like the lights on your motorhome. You will need to use the Roadmaster Universal Wiring Kit with Smart Diodes…

view full answer...

Answer 12

For vehicles where it's nearly impossible to find a dedicated stop light circuit the Roadmaster Universal Stop Light Switch Kit #RM-751000 is a great solution. Basically it gets power from your battery and has it's own switch that you install…

view full answer...

Where is Height of Surco RV Ladder SP502L Measured

Product Page this Question was Asked From

Continue Researching