Recommended Camper Steps For Evergreen Trailer

Question

Question:

I am interested in purchasing a set of Brophy camper scissor steps for my Evergreen iGo travel trailer. I have two questions: 1 The height of the door sill is 30 inches, but the specs of the scissor steps lists 31 - 39 inches is the 1 inch difference a problem? and, 2 the horizontal depth from the outside wall of the trailer to the trailer frame member is 12 1/2 inches and the frame member is a steel i-beam is this a mounting problem?

asked by: Jim S

1

Helpful Expert Reply:

Since the distance from the bottom of your door sill is 30 inches I recommend steps like part # AS23.

These steps are 24-inches wide and 8-1/2 inches deep. These steps are designed to expand from 24 to 30-inches. The mounting bracket and screws are included. Just secure the bracket to your camper and clip the stairs into the "V" clamps on the mounting bracket. Since you said you have a steel beam, you will need to drill into the frame to mount the step bracket.

expert reply by: Jeffrey L

1

Answer 1

Hey Al, this is a great question but since you have free-backing plates now you would never need to mess with the manual lock out of your Atwood coupler.

view full answer...

Answer 2

Are you basically asking how much length would this coupler add to the tongue of your trailer?

view full answer...

Answer 3

Sounds like you'd want to go with a removable scissor setup like the Brophy Camper Steps part #AS24 which will need to be taken off it's mounting bracket between uses. This will give you total access to your trailer hitch when needed.

view full answer...

Answer 4

I was able to confirm with my contact at Lippert that you can use the Replacement Circuit Board w/ Wireless Remote for HappiJac Electric Truck Camper Jack Systems #LC733540 to replace the circuit/control board on your corded HappiJac system. You can…

view full answer...

Answer 5

Well that stinks to hear; I'm sorry someone was lousy enough to steal from you. And while we do have an option for you, the older wired remote is not available as a replacement part. So what you would need to do instead is replace the circuit…

view full answer...

Answer 6

You can use the Go Power #34264403 Automatic Transfer Switch for 30 amp service. This transfer switch automatically changes from inverter to shore power when you hook up at the campground. It also protects your electrical system from AC power…

view full answer...

Answer 7

The mounting bracket for the Brophy Camper Scissor Steps #AS23 is 24 inches long and has 5 mounting holes spaced 5-1/4 inches apart. The end mounting holes are 1-1/2 inches from each side. Also, each angle is 1 inch wide. If you're looking for…

view full answer...

Answer 8

I went to the warehouse and pulled one of the Aluminum Scissor Steps, part #AS23 to take a measurement for you. I have attached a photo of the top mounting strip and step you can check out. The distance from the mounting strip on the step assembly to…

view full answer...

Answer 9

I attached a wiring diagram for the Progressive Dynamics Converter #PD4135K for you to check out. On the right side of the diagram you'll see the connections that run to the battery and on the left side you see the connections that you'd run…

view full answer...

Answer 10

Yes, any 12 volt power accessory is going to function as long as the battery/batteries are charged even if you are not connected to shore power. You want to run the 12 volt accessories through the Progressive Dynamics RV Power Control Center with…

view full answer...

Recommended Camper Steps For Evergreen Trailer

Product Page this Question was Asked From

Continue Researching