Could Surge Actuator part # T43397007K be Welded onto Trailer
Question:
can surge brake T43397007K be welded on
asked by: Miles B
1
Helpful Expert Reply:
Yes, the coupler part # T43397007K that you referenced could easily be welded onto your trailer. However, this coupler is zinc plated so it would need to be welded in a very well ventilated area.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator - Drum - Multi-Fit Ball - Bolt On - 7,000 lbs
- Brake Actuator
- Surge Brake Actuator
- Straight Tongue Coupler
- Bolt-On
- 7000 lbs GTW
- 1-7/8 Inch Ball Coupler
- 2 Inch Ball Coupler
- Drum Brakes
- No Lockout
- Dexter
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Replacement Drum Brake Actuator for a 1995 4 Winns Model 3916 Trailer
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement for Atwood Surge Brake Actuator 82541
- Q&A: Surge Brake Actuator Recommendation to Replace Fulton A60 on Trailer
- Q&A: Best Replacement for Atwood 82543 Brake Actuator
- Q&A: Can the Replacement Atwood Master Cylinder 85736 Still Be Obtained
- Q&A: How to Keep LED Turn Signal Lights on Toolbox From Flashing with Brake Pedal Pressed
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)