Maximum Towing Capacity of 2011 Cadillac CTS with Curt Class I Trailer Hitch Receiver
Question:
Im looking at C11196. Can I tow 2000 pounds with the cadillac cts? Thx
asked by: Rob
Helpful Expert Reply:
I looked at an online copy of the owner's manual for your 2011 Cadillac CTS and it states that your car can tow no more than 1,000 pounds. You should check your owner's manual to verify this.
The Curt Trailer Hitch Receiver # C11196 has a maximum towing capacity of 2,000 pounds however this will not increase the capacity of your Cadillac. You are limited by the lowest rated factor which in this case is the car.
If you're going to use the hitch to carry anything other than a trailer (Like a bike rack) you'll also need the Curt Trailer Hitch Support Strap # 18050 in order to be within the guidelines of Curt's warranty.
Since you mentioned towing you may also need a wiring harness for the CTS. The Curt T-Connector # C56044 is confrimed to fit. This installs by plugging into factory connectors behind your tail lights.
The Curt Class II Drawbar # C45521 is then recommended with either a 2 inch, # A-82, or 1-7/8 inch, # A-80, hitch ball. You'll also need a pin and clip, # F-4.
Products Referenced in This Question
Curt Cam Buckle Stabilizing Strap for Hitch-Mounted Accessories - 61" x 1" - Qty 1
- Accessories and Parts
- Hitch Bike Racks
- Hitch Cargo Carrier
- Tie Down Straps
- CURT
more information >
1-7/8" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 1-7/8 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- 2000 lbs GTW
- Class I
- Class II
- CURT
more information >
2" Hitch Ball - 3/4" Diameter x 2-1/8" Long Shank - Stainless Steel - 3,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Stainless Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 3/4 Inch Diameter Shank
- 3500 lbs GTW
- Class I
- Class II
- CURT
more information >
Curt Class II Drawbar - 2-5/8" Rise, 3-1/4" Drop - 7-1/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 3 Inch
- Rise - 2 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- CURT
more information >
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Curt Hitch Pin and Clip for 1-1/4" Hitches - 1/2" Diameter x 2-1/2" Span
- Hitch Pins and Clips
- Standard Hitch Pin
- 2-1/2 Inch Long
- Fits 1-1/4 Inch Hitch
- 1/2 Inch Diameter
- 2-1/2 Inch Span
- CURT
more information >