Tire Chain Fit Info for Tire Size 285/55-20

Question

Question:

I would like information and assistance in deciding which tire chains to purchase for my vehicles for an upcoming trip. The tire size is 285 55 20.

asked by: Keith B

0

Expert Reply:

For your tire size we have on chain setup that is a confirmed fit. For that you would want the part # TC3231SCAM which is a confirmed fit.

You will need to check the owners manual of your vehicle to determine if there are any tire chain restrictions as well.

expert reply by: Jameson C

0

Answer 1

Since your trailer has been over its weight capacity most likely the problems you are experiencing with your tires are directly related to this. I would recommend getting the weight of the trailer under the capacity and then check the suspension…

view full answer...

Answer 2

Trailer axles are designed to have the bow in them that you described. This allows the axle to flatten out when it is loaded and have the proper camber. If you have axles that are rated for considerably more than what the trailer will ever have…

view full answer...

Answer 3

I contacted Dexter with the serial number from your Dexter Torsion axle on the 2019 Lance 1985. The outer bearing is part #L44649 and the inner bearing is part #L68149 with a Dexter seal 010-019-00 which measures 1.719" inner diameter. You can…

view full answer...

Answer 4

It could be a tow package fuse on the vehicle. Use the owners manual to find the locations of fuses/relays related to the tow package wiring to check them and replace as needed. If the issue is not a fuse or relay then you can test the vehicle side…

view full answer...

Answer 5

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to install…

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 9

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 10

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 11

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 12

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Tire Chain Fit Info for Tire Size 285/55-20

Product Page this Question was Asked From

Continue Researching