Testing Wiring On 2003 Volvo S60 For Function When Installing New Lights
Question:
Hi. My front left blinker harness has a brown/white stripe wire and there is a white and green wire. Is the white a ground wire and the brown/white the hot. I am hooking up an led light with a resistor. Thank you.
asked by: Brian
0
Expert Reply:
The best way to find out what the wire functions on a vehicle are to use a circuit tester.
I recommend part # PTW2993. Then have someone run through the functions while you test the wires you have on your Volvo. This takes any guesswork away when installing any lights.
expert reply by:
Jeffrey L
0
Products Referenced in This Question
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Where is the Dummy Plug to Install a Brake Controller Adapter on 2019 Chevrolet Silverado 1500
- Q&A: Parts Needed For Flat Towing a 2024 Ford Maverick Behind a 2010 Winnebago Journey With Air Brakes
- Q&A: How To Wire In The V-Shaped Identification Light Bar When Replacing Light With Only 1 Wire
- Q&A: Caliper Bolts for AL-KO/Hayes Disc Brake Caliper BP18-050
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Oil Seal for AL-KO 568303
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule
- Q&A: Which Instructions Are Used Installing a Roadmaster Brake-Lite Relay in a Ford F-150 w/ Neutral Tow
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)