Why Cant the Bumper Mounted Hitch Recevier UF35-946401 Be Installed on Decorative Bumper Cover
Question:
Why can this hitch NOT be attached to an aluminum covered bumper?
asked by: Becky F
0
Expert Reply:
The Ultra-Fab 2 Inch Motor Home Trailer Hitch Receiver # UF35-946401 is not designed for use on decorative aluminum bumper covers because the installation of the receiver and the weight of the accessory used in the receiver would likely damage the decorative aluminum cover.
When the bumper cover becomes damaged, the receiver would no longer be installed securely enough on the bumper and could move while a hitch accessory is being used.
expert reply by:
Victoria B
0
Product Page this Question was Asked From
Ultra-Fab 2" Motor Home Trailer Hitch Receiver for 4" x 4" Bumpers
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 100 lbs TW
- 2 Inch Hitch
- Bolt-On
- Ultra-Fab Products
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Replacement Shock Absorber
- Q&A: Replacement 250-031468 Seals Needed for Reliable Oil Bath
- Q&A: Why Yakima HoldUp Bike Rack Is Not Rated For RVs
- Q&A: Will 8 Lug Spare Tire Fit on Curt Trailer Hitch Mounted Spare Tire Carrier
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Frame Mounted Trailer Hitch for Travel Trailer
- Q&A: How to Carry a Spare Tire and Bike Rack on a Class C Ford E-450 Motorhome
- Q&A: Replacement Gear Box for Atwood 5th Wheel Landing Gear with a 75721 Motor
- Article: Trailer Hitch Receiver Sizes
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)
- Article: How to Charge a Dump Trailer Battery
- Article: How to Measure a Trailer Axle