Replacement Bolts and Knobs Only for a Thule Summit Cargo Box

Question

Question:

I just need the bolts and three side wing nuts for a thuli summit ski carrier box

asked by: Dave R

0

Expert Reply:

The carriage bolts used for the Thule Summit cargo box are # TH10403, sold in quantities of 1. The knob is # TH04877, also sold in quantities of 1.

If you need all of the bolts and knobs then you will need 8 of each.

expert reply by: Michael H

0

Answer 1

We have exactly what you need for your Thule Summit! Take a look at the: -Replacement QM3 - Quick Mount Hardware - for Adventurer Cargo Box #TH04997. Even though it does not say it's for a Summit cargo box, this is the same hardware that…

view full answer...

Answer 2

You can mount the Thule Sidekick to one side or the other when installing it on a roof rack cross bar. We recommend you put it closer to the passenger side so that if you were on the side of the road you would be on the side of your vehicle that…

view full answer...

Answer 3

The U-bolt part #TH02943 that you referenced is 4 inches wide when measured from center to center of the threaded portion of the u-bolt. Check out the picture I attached that shows this dimension.

view full answer...

Answer 4

I am going to assume that your 2014 Toyota RAV4 XLE is already equipped with a roof rack. In order to make a recommendation for a roof top carrier I will need to know the type of crossbars used for your roof rack system, the minimum and maximum…

view full answer...

Answer 5

The Thule Sidekick Roof cargo Box, #TH78GC, outer dimension are as shown in the attached pictures. Overall external length is 54 inches and width is 25 inches. The height at its tallest point is 15-1/2 inches. At its shortest point the height is 10…

view full answer...

Answer 6

It sounds like you are looking for a replacement U-bolt that measures 4 inches wide. We do carry part #TH09243, that measures 4 inches wide and 2 inches deep. I have included a photo of this U-bolt with the dimensions noted you can check out. This is…

view full answer...

Answer 7

The Replacement Wingnut #TH04877 you were looking at is designed to work with M6 Bolts. So as long as your Thule cargo box uses an M6 bolt this will work perfectly for you.

view full answer...

Answer 8

I went out and pulled a Carriage Bolt M6-1 x 75mm #TH10403 from our warehouse to measure the square portion of the bolt and found that it measures .31 of an inch.

view full answer...

Answer 9

For your Thule Summit Cargo Box, the correct mounting hardware kit is the QM3 Quick Mount Hardware #TH04997. This kit includes all of the needed mounting hardware to attach the Thule Summit to the crossbars on your vehicle's roof. We do also have…

view full answer...

Answer 10

The replacement wing knob #TH04877 that you referenced fits a 6mm M6 bolt, such as carriage bolt part #TH915-0675-11 or u-bolt part #TH02943. According to my contact at Thule/SportRack this knob fits a variety of applications for both brands'…

view full answer...

Answer 11

The threads inside Thule replacement knob #TH04877 are metal. I have included a picture where you can see a little bit of the inside part.

view full answer...

Answer 12

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Replacement Bolts and Knobs Only for a Thule Summit Cargo Box

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching