What Trailer Hitches Fit a 2011 Kia Sorento with Dual Exhaust
Question:
I note that this hitch will not work on a 2011 Kia Sorento with dual exhaust? What models have the dual exhaust you mention as could not tell if you mean split ie one exhaust on right and one on left or two exhausts on right side of vehicle? Will onlly teh Curt hitch though ligher weight work with a dual exhaust? Please explain further. SAme goes for similar Draw-Tite model. Thanks.
asked by: Doug T
Expert Reply:
By dual exhaust, it means exhaust pipes on both the driver and passenger side of the vehicle. The type with two small pipes on the same side would still be considered single exhaust. All three available trailer hitches for the 2011 Kia Sorento will fit models with the single exhaust.
The Curt trailer hitch, # C13004, will fit a dual exhaust model as it is shaped to fit around this type of exhaust on both sides. The Draw-Tite # 75684 is designed to fit only the single exhaust models (the cross member on the right side is lower to allow the hitch to fit around the exhaust. I have included a link to the installation for each hitch below.
Products Referenced in This Question
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement for Gabriel Shock Model 610712
- Article: How to Measure a Trailer Axle
- Q&A: Recommended Replacement For A JVR9000R RV Stereo System With Three Cameras
- Q&A: Option to Replace Jensen JRV9000R
- Q&A: Taillight Converter Needed To Separate Brake Lamp and Turn Signal Circuits
- Q&A: 40' Wishbone Trailer Wiring With A Ground Wire Running Down Both Sides
- Q&A: How To Convert A Wishbone Trailer Wiring Harness To A Regular 4-Flat Trailer Wiring Harness
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: What is Amperage Draw of Lippert Ground Control Leveling System # LC358590
- Article: Roadmaster Vehicle Specific Base Plates
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)