Will Curt Trailer Hitch # C13073 Fit a 2010 Hyundai Santa Fe With Under Mounted Spare Tire Carrier
Question:
Will the Curt hitch C13073 fit on the 2010 Hyundai Santa Fe with 3.5L V6 and AWD single exhaust with the spare tire in place temporary tire/carrier in rear under vehicle - between frame rails and muffler? If not, will the Draw-tite 75684 fit with the spare tire? Also will the hitch whichever ? need to be removed to access the spare if needed. Thank you
asked by: Chance
Expert Reply:
Is the spare tire carrier you are referring to a factory option, or is it something you installed aftermarket? The Curt hitch # C13073 may work, as a space saver tire carrier is visible in the installation pictures, but it does have a closer fit than the Draw-Tite, as it runs above the exhaust. We do not have any confirmation on whether any of the hitches available for the 2010 Hyundai Santa Fe would or would not work with an aftermarket under mounted spare tire carrier.
I would recommend checking the installation area for the hitch to make sure the spare tire and carrier would not be an obstruction. All the hitches for your vehicle would attach at the same point, using the two weld nuts on the vehicle frame, close to the exhaust.
If you do find that the spare tire does not obstruct the installation area, the Draw-Tite # 75684 would most likely still give you more room with which to work, since both run below the exhaust.
I have linked the installation instructions for the Curt and the Draw-Tite models below.
![Sarah L](https://images.etrailer.com/static/images/catg/people/190_tn.jpg)
Products Referenced in This Question
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Hubs and Brake Assemblies for Dexter Mobile Home Axle and 8-147 Hubs
- Q&A: Distance Between the Mounting Holes on the Curt 5-Postion Adjustable Channel Bracket
- Q&A: Replacement for Gabriel Shock Model 610712
- Article: How to Measure a Trailer Axle
- Q&A: Replacement for Parallex 500 Series Model 555 Converter
- Q&A: Taillight Converter Needed To Separate Brake Lamp and Turn Signal Circuits
- Q&A: Recommended Replacement For A JVR9000R RV Stereo System With Three Cameras
- Q&A: Option to Replace Jensen JRV9000R
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: My Trailer Hitch Doesn't Fit
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting Brake Controller Installations
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)