What Wire Gauge Required for +12V Trailer Power Circuit to Run A/C Unit
Question:
I have 10 gauge wire and only 1 a/c unit should that be large enough and its a 20 amp breaker
asked by: Janet
0
Expert Reply:
We recommend 10-gauge wire like # 10-1-1 for any 12V trailer power wiring. This wire gauge can be used with circuit breakers up to 40-amps, so it will be fine for use with your 20-amp breaker, like # PK54520. You'll want to check the power draw for your A/C unit to ensure it does not exceed the capacity of the circuit breaker you're installing.
expert reply by:
Adam R
0
Products Referenced in This Question
Pollak Circuit Breaker - Cycling/Automatic Reset - 20 Amp - Straight Mount Bracket
- Accessories and Parts
- Wiring
- Circuit Breaker
- 20 Amp
- Pollak
more information >
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Brake Controller Installation on 2016 Mercedes-Benz Sprinter
- Q&A: Tool for Adjusting Drum Brakes on Drop Axle
- Q&A: Does a 2022 Chevrolet Silverado 3500 Short Bed Need a Sliding 5th Wheel Hitch
- Q&A: Picking Between ETBC7 and ETBC7L for Brake Controller Install
- Q&A: What is the Difference Between a Class II and a Class III Hitch?