Troubleshooting Hard to Thread Install Bolts for a Hitch on a 2012 Kia Sorento
Question:
We got our hitch in and cant get the bolts in what so ever. I read on your site that we will put in a 10 mm bolt. But at the top of the bolts you supplied it says 10.9 Are the ones you supplied wrong?
asked by: Andy A
Expert Reply:
Before we determine that you have the wrong size install bolts you need to make sure that the bolts not fitting isn't due to the weld nuts of your vehicle being dirty/corroded and that is why they won't fit.
Typically on vehicles that have seen a few winters the weldnuts can be a bit dirty/corroded so bolts will not just thread right into them. Check out the links I attached that detail how to clean the weld nuts.
The 10.9 on the bolt head is not the size of it.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class IV
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Trailer Wiring
- Shop: T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Q&A: Bolts Needed to Install the Curt Trailer Hitch Receiver # C13073 on a 2012 Kia Sorento
- Video: How To Clean Weld Nuts
- Video: Advent Air RV Air Conditioner with Air Distribution Box and Start Capacitor Installation
- Q&A: What Size Bolts Come with Draw-Tite Part # 75684
- Shop: etrailer Ball Mount Kit for 2" Hitches - 7,500 lbs
- Shop: Advent Air RV Air Conditioner System - Manual - 13,500 Btu - White
- Q&A: Cleaning Threaded Holes on a 2011 Kia Sorento to Install a Draw-Tite part # 75684
- Q&A: Class III Hitch Recommendation For 2013 Kia Sorento LX
- Q&A: Will Draw-Tite # 75684 Fit on a 2012 Kia Sorento SX with Dual Exhaust on the Passenger Side
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Search Results: 44649
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: 25580
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: Brake Controller
- Search Results: 68149
- Article: Trailer Wiring Diagrams
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Choosing the Right Brake Controller
- Search Results: dust cap