Parts Needed to Install a Brake Controller in a 1999 Isuzu NPR with 7-Way
Question:
I have a 7 way connection on my truck, what else is required to hook up a brake controller. Thanks in advance
asked by: Paul M
Expert Reply:
Since you have a 7-Way you will only need a few more components to complete a brake controller install on your vehicle.
First let's start with a brake controller. I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to setup.
Next, for a wiring kit to install the brake controller and the 7-way adapter you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.
Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.
I attached an FAQ on installing brake controllers for you to check out.
Products Referenced in This Question
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Replacement for Global Direct GDC80 Brake Actuator
- Q&A: Replacement Brake Actuator for Global Direct GDC-80 Brake Actuator
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Where Does Curt Trailer Wiring Harness Install on a 2000 Toyota Tundra
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How Does the Hopkins 7-Way part # HM40975 Wire to a Vehicle
- Q&A: Trailer Hitch for a 2018 Hyundai Elantra GT
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Determining Correct Wiring Harness for 2001 Toyota Tundra
- Article: Types of Bumpers
- Article: Testing Brake Controls