What Fittings Are Available For Connecting A Transmission Cooler To A 2007 Chevrolet Tahoe

Question

Question:

I am trying to find the fittings for the radiator and transmission lines for a 2007 Tahoe. I am trying to install a tranny cooler, but the fittings I have seen are either too small or too large.

asked by: David K

0

Expert Reply:

Here are some of the fittings that I have available that are used to connect a transmission cooler to a radiator on a 2007 Chevy Tahoe. You might want to try and measure the fitting size that is on your vehicles radiator.

The Derale Insta-Dapt Radiator Adapter, # D13004, is used in the transmission coolers that we sell. It is a radiator adapter that fits most vehicles with 5/16 inch transmission lines.

The Derale Radiator Adapter Fittings for GM, # D13018, are 5/8 inch inverted flare fittings that will connect the transmission cooler without cutting lines.

I also have a Derale Single-Hose Transmission Cooler Installation Kit, # D13006, which will include all the hardware needed to mount a transmission cooler to your vehicle.

expert reply by: Jeff D

0

Answer 1

The Derale Series 8000 Transmission Cooler #D13503 will work perfectly on your 2007 Cehvrolet Suburban. You will not need the Derale Single-Hose Transmission Cooler Installation Kit #D13006 unless you do not have a stand-alone transmission cooler and…

view full answer...

Answer 2

The differerence between the three coolers you mentioned is the size overall. The #D13503 measures 11" Wide x 8-3/4" tall x 7/8" deep. The part #D13502 measures 11" Wide x 7-1/4" tall x 7/8" deep (slightly shorter) and…

view full answer...

Answer 3

A supplemental transmission cooler is always a good idea for vehicles with automatic transmissions. Cooler fluid means less wear on the transmission. This is especially helpful when towing so I do recommend a supplemental cooler for your 2015 Chevy…

view full answer...

Answer 4

I would recommend air bags like the Firestone kit part #F4186 that fits your 2008 Cadillac Escalade with autoride suspensions over Timbrens as the Timbren kits have a reputation of being kind of harsh when unloaded which is not something anyone would…

view full answer...

Answer 5

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

view full answer...

Answer 9

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based on…

view full answer...

Answer 10

The best option we offer for your dump trailer is the Erickson Mesh Tarp and Truck Bed Cover part #EM57059 which measures 12' wide x 16' long. It's not the exact dimensions you wanted but it will still cover most of the area you need it…

view full answer...

Answer 11

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 12

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

What Fittings Are Available For Connecting A Transmission Cooler To A 2007 Chevrolet Tahoe

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching