Recommended Magnetic Mount Utility Lights

Question

Question:

Looking for a low cost set of utility flood lights that could be mounted on strong magnets to use on the ROPS of a tractor for digging and snowplowing. I want magnets so they could be relocated on tractor or ROPS for backhoe or other use.

asked by: Jack

0

Expert Reply:

For magnetic mount utility lights, we offer the Wesbar LED Utility Light - Rectangular # 54209-018 and Round # 54209-017.

We do not have any utility lights that are designed to mount to a magnet. If you would like to mount them to a heavy-duty magnet you will want to fabricate some sort of mount that will work for you.

I have attached a link to all of our white utility lights for you.

expert reply by: Victoria B

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 4

According to my research it looks like your 2013 Prime Time LaCrosse has a front porch light similar to the LED Porch and Utility Light for RVs #RVPLL13AB so if it matches the dimensions (see attached) then the Replacement Clear Oval Acrylic Lens…

view full answer...

Answer 5

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 6

The AL-KO company was bought out by Dexter, so he may have been thinking Dexter axles which the #K23-478-00 and #K23-479-00 would fit with the 4 bolt mounting pattern. The K23-538-00 and K23-539-00 are the correct ones for the AL-KO T-44 axle, as you…

view full answer...

Answer 7

You can use the RV Propane Gas Detector #RS64FR to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 8

I spoke with my contact at Curt, who tells me that you can simply disconnect the existing exhaust hanger, install the hitch, and then use the bolt shown in the diagram I have provided to reinstall the bracket. The bolt would pass through the exhaust…

view full answer...