Trailer Roof Vent Recommendation for a Horse Trailer with Thin Metal Roof

Question:

I am looking for a square crank up roof vent for my horse trailer to replace an old one. It is a 12 inch low profile vent and the roof is just a single wall metal roof. The opening in the vent is about 10 inches and the trim is about 12 inches wide. The current one is riveted on. Do you carry something to replace it with? Most the rv vents are for a 2inch roof not a thin metal roof.

asked by: Kevin M

Expert Reply:

If you didn't mind enlarging the hole in the roof of your horse trailer you could use the part # V2110SP-24 as a replacement vent. Since your roof is so thin you could just go without the garnish and attach it directly to the roof.

For an install kit with screws and sealant you would also want the part # 344270KITW.

expert reply by: Jameson C