What Is Recommended Spacing Needed When Installing E-Track By Welding
Question:
If welding e-track to a metal floor car hauler what is the recommended spacing intervals of placing the welds if using an @2inch long bead?? I dont think there would be a need to weld the entire length of the e-track. Would you recommend putting the beads on each side of the e-track of course every 12, 8, 6foot ????
asked by: Rick G
Expert Reply:
Since there is not a set rule on the fastener spacing, it would really depend on the amount of stress you think there will be on the E-Track. The more locations that the track is secured the better. Unless the track will be under a tremendous amount of stress I don't think a solid weld the length of the track is necessary.
The same rule applies if using bolts or screws to mount the E-track. The holes are spaced 2 inches apart center to center.
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- E-Track
- E-Track Rails
- Horizontal
- 5-1/8 Inch Wide
- 2000 lbs
- 5 Feet Long
- Erickson
more information >
Continue Researching
- Shop: Trailer Hitch
- Shop: B&W Heavy-Duty Trailer Hitch Receiver - Custom Fit - Class V - 2"
- Q&A: Spacing the Tracks When Installing E-Track to Metal Floor of Car Hauler
- Shop: Replacement Head Assembly for B&W Companion 5th Wheel Trailer Hitches - 25,000 lbs
- Shop: Replacement Head Assembly for B&W Patriot 5th Wheel Trailer Hitch - 18,000 lbs
- Shop: MB Sturgis Propane Adapter Fitting - 1/4" Male NPT x Male Type 1
- Shop: Center Section for B&W Turnoverball Underbed Gooseneck Hitch - 30,000 lbs
- Q&A: Replacement for Grease Seal 21333TB
- Shop: Rubber Window Edge Weather Strip for RVs - Press In - 12' Long x 1/2" Tall
- Shop: Rubber Window Edge Weather Strip for RVs - Press In - 20' Long x 3/4" Tall
- Search Results: 379147
- Search Results: lc379147
- Search Results: e track
- Q&A: Installing E-Track to Metal Floor of Car Hauler
- Q&A: Are the Erickson Horizontal E-Tracks Strong Enough for a 5,000 lb Vehicle
- Q&A: Can E-Track Be Used To Secure a Car in a Trailer?
- Search Results: demco ez latch
- Search Results: drop leg trailer jack
- Q&A: Installation Methods for Brophy Recessed Trailer D-Ring Tie Down with Backing Plate # RR5K
- Q&A: Installation Process and Weight Capacity of Erickson E-track System
- Search Results: trailer brake controller
- Shop: Brake Controller
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Trailer Wiring
- Shop: Trailer Wiring
- Search Results: 44649
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Brake Controller
- Shop: Fifth Wheel Hitch
- Article: Trailer Wiring Diagrams