Can the Pintle Hook Mount, 12-1/2 Inches Tall, 8K, # 63058, Be Used in the Rise Position

Question

Question:

I need to raise my pintle hitch about 6-8 inches to keep my M105 level...can this be flipped to raise my hitch point? thanks!

asked by: timm b

0

Expert Reply:

The Pintle Hook Mount, 12-1/2 Inches Tall, 8K, # 63058, can be used in either the drop or rise position, which ever would work best to keep your M105 trailer the most level. You would need to use the maximum number of mounting holes on the Mount that your Pintle Hook will allow.

expert reply by: Michael H

0

Answer 1

I have the perfect solution for you! The Patriot Hitches Adjustable Drop Hitch #PH67SR will be exactly what you need. This will fit your 2" receiver and can be adjusted to rise or drop 2-1/2" up to 11". This is going to be your best…

view full answer...

Answer 2

Yes, if you wanted to use the Curt Pintle Hook with 2-5/16" Ball #C45908 that you referenced in the rise position you certainly could. You'd flip the hook combo as well as the shank upside down and you'd be set.

view full answer...

Answer 3

That really depends on the weight of the trailer plus the weight of any cargo you plan on putting in that trailer. I would recommend you check out the link I attached to the right that shows all of the Titan actuators we carry, select the weight…

view full answer...

Answer 4

We have just what you need! For your 2021 Toyota 4Runner I recommend the Mounting Panel #331-TPSI-002 which was designed specifically for your vehicle and will replace one of the blank switches on the left side of your steering wheel. This will allow…

view full answer...

Answer 5

You should just need an electric over hydraulic actuator such as #HBA-10 for drum brakes or #HBA16 for disc brakes. You should not need any additional brake lines or anything because the actuators work with the hydraulic lines and brakes that are…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 8

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 11

The 40 amp fuse for your 2006 Chevrolet Silverado tow package is used for the 12 volt battery charge circuit. This fuse is located toward the front of the underhood fuse box closest to the front auxiliary positive post (see photo). There may be a…

view full answer...

Answer 12

On a 2005 Chevy Silverado 1500, If you are facing the front of the truck looking at the power distribution box, there will be a post at the back left side and a fuse slot near it. It is that fuse slot that you will install a 30 amp fuse. I have…

view full answer...

Can the Pintle Hook Mount, 12-1/2 Inches Tall, 8K, # 63058, Be Used in the Rise Position

Product Page this Question was Asked From

Continue Researching