Filter Results
$63.86 - $115.88
$222.83 - $397.54
Videos
for Trailer Fenders
Help Articles
for Trailer Fenders
Expert Answers
for Trailer Fenders
Torque specs for wheel lug nuts will vary depending on the diameter of the lugs, type of lug nut and the wheel's material. The…
view full answer...Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be…
view full answer...I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for…
view full answer...Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the…
view full answer...It's totally normal for a bit of movement between any fifth wheel hitch and the base rails. The feet on the hitch are typically a…
view full answer...The Curt Adjustable Width Trailer Hitch Receiver for RVs #13703 uses frame brackets for installation, and those need to be positioned on the inside of an I-beam frame, as per the instructions (a copy of which I have linked for you). That is what…
view full answer...There are 2 different capacities independent of each other though related. Tongue weight is the downward force or weight on the trailer hitch. So it is pushing down at the back of the vehicle. The gross trailer weight is the weight of whatever it…
view full answer...There is not a fuse we carry for the 8000 Series of Fan-Tastic vent. It does use a 4 amp slow blow fuse so to make fuse access simpler you can use In-Line Fuse Holder #C58470-1 and if you need to replace the bow-tie bracket, motor, and blade the…
view full answer...90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.
view full answer...Replacement arms are available for the Roadmaster EZ5 Base Plate Kit #RM-521569-5 for your 2015 Honda Fit with the part #RM-ARMS. When the original base plate brackets and arms were manufactured, they were made as one part. To be sure that the new…
view full answer...Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit…
view full answer...The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack…
view full answer...