Hey Morgan, so you are right we don't carry the Trailer Butler dolly but we do have a really great alternative with the Trailer Valet #TVRVR3 which is a similar electric dolly design and ALSO has a fancy name... I like this…

Hey Scott, thanks for reaching out! The Trailer Valet RVR3 Remote-Controlled Trailer Dolly #TVRVR3 does sound like the right solution for you, and you can get that heavier tongue weight by either loading some heavier stuff in that front compartment…

Yes both of the Trailer Valet Remote-Controlled Trailer Dollies #TVRVR5 and #TVRVR3 have internal brakes that are automatic. What this means is that unless you are intentionally moving them they will not move or roll. The 5 is just as ball mount…

You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get…

I took a look at the manual for the Trailer Valet RVR3 Remote-Controlled Trailer Dolly part #TVRVR3 and the following is what they recommend for storage. "Put the RVR in the transport box/bag delivered from the factory. If…

I would be happy to! The bottom of the foot to the center of the pipe mount is 10-1/2" when retracted and 24-1/2" when fully extended on the Trailer Valet JXS Trailer Jack w/ Footplate and Drill Powered…

Yes, the Curt hitch part #C77ZV is a fit for the 2023 Toyota Crown Hybrid. I attached a link to the install instructions as well as a link to an installer finder in case you wanted to find someone near you to install the hitch.

Hi Bill, The Fastway e2 Weight Distribution w/ 2-Point Sway Control #FA92-00-0450 has a tongue weight range of 200lbs - 450lbs so you'd be right around the middle of the capacity when loaded, making this a great choice. This…

I made a quick diagram for you to check out, but the lowest bolt hole on the Trailer Valet Remote-Controlled Trailer Dolly #TVRVR3 will be at 13-1/2".This means that this will be where the bottom most part of your trailer frame…

We do not have any hub caps that fit trailer wheels. If you were wanting to go with something nicer looking you'd need to replace the wheel with something like the Westlake ST205/75-14 part #WST57FR or any of the other aluminum…

The Trailer Valet 5X #STC-V211 has a silver/grey powder-coat finish that in some light and on certain screens can appear darker. The appearance will vary depending on how the photography was done and on the size and type of viewing device (PC…

The Trailer Valet RVR9 Remote-Controlled Trailer Mover #TVRVR9 is a 4-motor device. There are other versions of this unit that use fewer motors but this one has 4. The maximum surface slope compatible with this device is 5 degrees. I did confirm…