My contact at SportRack tells me that they haven't come across any fit problems with the H3, but I'd recommend taking two measurements for confirmation.
There are two possible clearance problems you could encounter, if the shank on the rack is long enough to allow the rack to be fully inserted into the receiver so the hitch pin holes line up, and if the rack will swing to the right far enough so that the rear door can be fully opened.
For the first issue, you'd need to measure rearward... view full answer...
Yes, I confirmed with Pacer that the Pacer Performance Hi-Five LED Truck Cab Light Kit # PP20-244 will fit your 2006 Hummer H3. The LED light kit has a positive and negative pigtail on them that can be attached using your current running-light setup. In addition, the lights # PP20-244C and the # PP20-244S will fit your 2006 Hummer H3 as well. view full answer...
Yes, the Adapter for Surco Safari Roof Racks # SPCH100 will mount to your factory rails allowing you to mount your Surco Safari Rack 5.0 Rooftop Cargo Basket for Factory Rails # SPS5060-1101 to your 2008 Hummer H3. view full answer...
The Yakima LongHaul 4-Bike RV Hitch Mounted Rack # Y02476, will fit on your Hummer H3 if the measurement from the center of your hitch pin hole to the furthest part of the spare tire is less than 9 inches. I have included review videos for this rack below.
The hitch mounted, tilting 4 bike rack with the most clearance is the Folding 4 Bike Dual Arm Rack - Swagman Trailhead, # S63380. It measures 13 inches from the center of the hitch pin hole to the back of the upright bar. I have included... view full answer...
We have a similar e-bike rack that would clear the rear spare of your 2008 Hummer H3 with the Yakima OnRamp part # Y36FR but the EasyFold XT does not have the needed clearance.
The OnRamp is a very similar E-bike rack that has a ramp that pulls out to make loading/unloading easier. view full answer...
Yes, the Yakima MegaWarrior Extra Large Roof Rack Cargo Basket part # Y07080 will mount to the factory crossbars you have on your 2009 Hummer H3 Alpha without additional purchase necessary. We have not yet installed this cargo basket on a Hummer H3 so I would not be able to confirm if it covers the sunroof but if the sunroof is positioned between the two crossbars then you can assume it will cover it. It is also not recommend to open the sunroof with the basket attached as the noise would... view full answer...
There is a good possibility that the Swagman Trailhead, # S63360, will clear the spare tire on your 2007 Hummer H3 as this rack has a fair amount of clearance. From the center of the hitch pin hole to the back of the upright bar, the distance is 14-1/2 inches.
You will need to measure the distance from the center of the hitch pin hole on your H3 out to the distance required to clear the spare tire. If this distance is less than 14-1/2 inches, the rack will fit. I have included a link... view full answer...
There is no cutting or trimming of the bumper on the Hummer H3 when installing the Draw-Tite Class III Trailer Hitch, # 75382. The installation on your Hummer H3 is a very simple bolt-on application. The hardest part might be lowering the exhaust for ease of installation.
I am sending a link to the installation instructions for the Draw-Tite Class III Trailer Hitch, # 75382.
If you will be towing, you will need the Curt Ball Mount, # C45010, and the Pin and Clip, # PC3. You will also... view full answer...
The item you selected, Thule Roof-Mounted Bike Carrier, part # TH859XT is designed to work with round, square, aero, elliptical, and most factory crossbars so it could work on your Hummer.
A Roof Mounted Bike Carrier I would recommend that would work with your Hummer, is the Fork Style Roof Mounted Bike Rack, part # S64710 . This bike carrier fits factory cross bars and will work great on your 2006 Hummer H3 with roof rack rail cross bars. Part # S64710, is similar to the Rola Roof-Mounted... view full answer...
The Safari Roof Cargo Basket part # SPS5084-1101 that you referenced is designed to fit the roof's of vehicles that have raised side rails that are on either side of the roof. So it would need 2 rails to fit and install. view full answer...
Yes, the Curt Front Mount Trailer Hitch Receiver # 31270 will fit a 2008 Hummer H3 Alpha. You will be required to permanently remove the front aluminum skid plate. view full answer...
Yes, you can use the RockyMounts HighNoon FC Solo Bike Rack for 1 Bike # RKY87RR. Since the RockyMounts HighNoon works with either a 1-1/4" shank or a 2" shank, I am certain that this will directly fit your 2006 Hummer H3 using the 2" hitch receiver like the one found on the Curt # C13270. view full answer...
The Thule SnowPack Extender Ski and Snowboard Carrier # TH7325 is listed as fitting most factory and after market load bars. I called Thule just to make sure and they confirmed the carrier will fit your Hummer H3 bars. view full answer...
The Rightline Gear Sport 3 Rooftop Cargo Bag - Waterproof - 18 cu ft - 48" x 40" x 19" # RL100S30 (18 cubic feet) will work well for your factory roof rack. This will attach to your factory roof rack to secure it or can be secured to the door jambs if preferred. The bag can fit over the rails so there isn't a minimum size.
Considering the height of your H3, you might want to include the HitchMate TireStep # HE4040. This is a slip-on wheel mount step that makes accessing your cargo... view full answer...
To see if the GearDeck 17 Enclosed Cargo Carrier for 2" Hitches # H00604, will fit on your 2006 Hummer H3 with a spare tire on the back there are a few things you will need to check out on your hitch and your vehicle.
The GearDeck, # H00604, can only be used on Class III and Class IV 2-inch hitches. So you will want to make sure you have a 2-inch hitch on your Hummer.
Next, you will need to measure the distance from the center of your hitch pin hole to the farthest back part of your spare... view full answer...
The Blue Ox Bolt-On Base Plate Bracket Kit - 5,000 lbs Item # BX88230 is compatible to be used with any vehicle as long as where it will be mounted is structurally sound enough to tow the vehicle. For instance some off road steel bumpers with D-ring mounts can not be used to tow a vehicle because they have not been tested by the manufacturer to see if they can hold up to the stress the movement of the vehicle puts on that area.
For your 2006 Hummer H3 I recommend Demco Classic Base Plate... view full answer...
As long as the vehicle is a 1996 model or newer equipped with an OBD-II port, you will be able to connect the Edge Insight CTS, # EP84130.
The Insight is not a tuner type of programmer. It can display several parameters and allows you to monitor them but you cannot tune the engine with it. It will not add horsepower, torque, or change any of the factory settings.
Some of the parameters you can monitor are:
Battery Voltage
Intake Air Temperature (IAT)
Engine Oil Pressure (EOP)
Engine... view full answer...
Yes. You can install the RedArc Tow Pro Liberty # RED24FR on a 2008 Hummer H3 using the available wiring under the dash. There is not a plug in adapter on the 2008 H3, so you would need to hard-wire in the brake controller, but the wiring is present to make this installation fairly easy. You'll want to use butt connectors like the # DW05745-5 to make the connections to the existing wires and you can use one of your existing slots on the dash to install the knob that comes with the Liberty.... view full answer...
The hitch you ordered is the Draw-Tite # 75382 which is a 2 inch Class III receiver. For a standard hitch pin and clip use part # PC3. If you prefer a locking pin part # e98882 will fit the hitch.
I've also linked our complete selection of ball mounts that fit. One I like to recommend is the B&W Tow & Stow, part # BWTS10037B. It's adjustable with two different ball sizes so it can be used with a large variety of trailers. It also flips under itself to a stored position to keep it... view full answer...
Go To Results