For your Thor Freedom Elite 30FE, the chassis is the Ford E-450 and the weight is around 14,500 lbs at max capacity. For your motorhome I recommend the SumoSprings Maxim Custom Helper Springs - Rear Axle # SSR-106-47-1. The stronger spring will help restrict body roll and give the support the weight of the vehicle requires.
The different capacities you referenced help with different weights and how much weight they support when they are individually compressed up to 80 percent. Although... view full answer...
I have a solution for you. Unfortunately, the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3035-P is the wrong adapter for your 2018 Thor Freedom Elite with a Ford E-350 Chassis. The part you need is the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3034-P. I went ahead and attached a video to show the installation process. view full answer...
The pilot hole size is the center hole diameter of the wheel. For example the Lionshead Steel Dual Wheel part # LHHA420 has a pilot diameter of 4.75 inches and since this is a hub-centric wheel that centers on the hub with it's pilot diameter this would need to be an exact match for what you plan to replace. view full answer...
Since you said you need a 90 degree fitting coming off of your regulator what you'd want is the MB Sturgis Propane Elbow Adapter # 204163 which comes with the correct size fitting on both ends. view full answer...
The Lippert High-Speed Power Stabilizer Jack - 30" Lift # LC337199 are typically used for trailers, but if your motorhome has enough clearance and you have access to the frame then you could potentially use this stabilizer.
The mounting holes for the # LC337199 are 68-11/16" from center-hole to center-hole so you'll need to ensure that the frame lines up with these holes.
If not, you could use a stabilizer like the Ultra-Fab Power Twin II Electric Stabilizer # UF39-941705, which can... view full answer...
Yes, when you order the SumoSprings Solo Custom Helper Springs # SSR-107-47 you get a pair of the springs. There will be one for either side on the rear axle. view full answer...
Many modern RV's have 75 Ohm Co-Ax INPUT jacks on their exterior where you can connect a satellite dish, Cable TV cable, or even an improved over-the-air TV antenna.
RV's that have in-the-wall cabling for interior TV locations usually place an outdoor jack to connect an outdoor TV as well.
I can see from your picture that this is an outdoor jack, but I cannot know if it is an INPUT jack or OUTPUT jack for an outdoor TV. Both jacks are identical in construction and function. Outdoor... view full answer...
I did some checking and since your 2018 Thor Freedom Elite 29FE is built on a Ford E-450 chassis with a V10 engine the rear sway bar you'd want is the part # RM-1139-147 and then for the front you'd want # RM-1139-176.
This will dramatically improve the ride and handling of your motorhome. view full answer...
The Surco, # SP502L is a universal mount ladder so yes this will be able to mount to your 2019 Thor Freedom Elite Motorhome. However, like all exterior RV ladders it will require a backing to be in place for proper mounting. I suggest you verify that your Motorhome was built with this in place before attempting installation. You will need to locate a stud or bulkhead for a solid attachment point. The best option is to contact the OEM to inquire where is best location to install. view full answer...
I don't know exactly what size you need for your 2015 Thor Freedom Elite but we do have RV compartment doors like the # SE26VR which is 18-1/8 inch by 20-1/2. This is our largest size but I attached a link to a page that has all of our options that are similar. view full answer...
If you're installing the Advent Air RV Air Conditioner System # ADV94FR as a second unit that's completely separate you'd most likely only need to purchase some wiring to go from the controller to wherever you plan on mounting the thermostat and just some electrical connectors to complete your connections. If the space doesn't have AC wiring ran to it then you would also have to run the wire and install a circuit breaker in your power center in order to power the system.
You wouldn't... view full answer...
To improve the ride quality in your 2014 Thor Freedom Elite motorhome I recommend the SumoSprings Maxim Custom Helper Springs - Rear Axle Item # SSR-106-47-1 and the SumoSprings Solo Custom Helper Springs - Front Axle Item # SSF-106-47. Both kits will improve ride quality by absorbing road shock and reducing body roll. As one is being stretched the other is being compressed and is pushing to return each back to it's normal state which reduced body roll. Both are constructed of a microcellular... view full answer...
Since your RV currently has incandescent lights and you're going to be replacing them with Triple LED # CE44VR you will need to add resistors like the Putco LED Light Bulb Load-Resistors - Aluminum - Qty 2 Item # P230004A-2 to the turn signal circuits. This will keep your blinker from hyper-flashing and allow them to function normally. view full answer...
If you had a hitch installed on your motorhome that hung below your rear bumper and you had the etrailer Cargo Carrier # e99049 installed on the bumper and folded up you'd easily be able to still tow a vehicle. Now if you wanted to have it fold down you'd have clearance issues most likely as the tow bar would most likely hit the carrier during elevation changes. view full answer...
I checked with Roadmaster for you, and verified that there is a rear anti-sway bar that fits your 2021 Thor Freedom Elite on a Chevy 3500 cutaway chassis, though there is not a front anti-sway bar that fits. The correct part number for the rear bar is the following:
- Roadmaster Rear Anti-Sway Bar # RM-1109-175
A rear anti-sway bar like # RM-1109-175 is the best way to enhance the ride of your motorhome because it acts as a brace between the frame of your motorhome, and is constructed... view full answer...
The Solera Power Awning Switch Kit # LC285500 does have 6 pins on the back of it, the included harness just has two internal jumper wires running between a few of the pins making it so there are only four wires.
Since your switch has 6 individual wires you would just disconnect them one at a time from your old switch, and install them one at a time in the same position of your new switch to make sure everything functions correctly. You will not need to use the included harness.
I included... view full answer...
I checked with SumoSprings and they recommend the black springs, so the SumoSprings Solo Custom Helper Springs part # SSF-106-47 for the front and the SumoSprings Maxim Custom Helper Springs part # SSR-106-47-1 or the SumoSprings Solo Custom Helper Springs part # SSR-130-47 for the rear on a 2022 Thor Freedom Elite with Ford E-450 Chassis.
Please note, if you have lines or anything on the outside of the frame, above the leaf springs where the Maxim will mount, you'll need to go with the Solo. view full answer...
We have two entry door lock options that can be keyless. I have listed them below, along with the cut-out dimensions that they fit. Unfortunately, your RV information does not tell me what size cut-out that you have, so you will want to verify that before ordering.
- Global Link Ultra E Pro Electronic Lock for Travel Trailer # 295-000183
cut-out size: 3-3/4" tall x 2-3/4" wide
- Global Link RV Entry Door Locking Latch Kit # GL55VR
cut-out size: 3-3/4" tall x 2-3/4" wide
This option has... view full answer...
For a carrier I recommend the Roadmaster Spare Tire Carrier # RM-195125. This will make it easier to load onto your 2021 Thor Freedom Elite and will not eliminate the receiver if you need to flat tow a vehicle behind you.
The only wheels we have are going to be trailer wheels, you will need to source the correct wheels and tires from a Ford Dealer or local tire and wheel shop. view full answer...
Go To Results