Expert Answers about Saturn Vue
- Adding a 7-Way Trailer Connector to a 2006 Saturn Vue
- In order to add a 7-Way trailer connector your Saturn Vue you will first have to install a 4-Way using # 118418. Then to add a 7-Way you have 2 options. If all you want is for the lights to work on the trailer when you tow it with the Vue then you would need # 37185. You would ground the white wire and the other wires can be capped off and stowed out of the way.
If you want all the functions of the 7-Way to work you would install the 4-Way but use # ETBC7 to add the 7-Way. If the trailer...
view full answer... - Rear Suspension Helper Springs for a 2005 Saturn Vue that Sags when Loaded
- The weight of the Thule T2 bike carriers loaded with bikes should not be enough by itself to cause the rear of the vehicle to sag or cause braking or steering problems. But when you add passengers and/or cargo then all of that combined is when you would see a problem.
A simple solution that will help with steering, stability, and sagging is to install Timbren helper springs # TGMRVUE. But braking is another issue. When the vehicle is loaded with people there is a lot of momentum and it...
view full answer... - What is the Correct Ball Mount for Draw-Tite Trailer Hitch # 36450 on a 2008 Saturn Vue
- Draw-Tite has indicated that the correct ball mount for hitch # 36450 for a 2008 Saturn Vue is # 36061 for use in the rise position only. For a pin and clip, you can use # PC2.
With Class I and II trailer hitches, only the manufacturer recommended ball mount should be used as it has been tested/determined to be the best option for the lower Class hitches and the vehicles they are designed for. Using a different ball mount will void the hitch warranty.
With Class III hitches and above,...
view full answer... - Recommendation for Hitch Mount Bike Rack and Receiver Adapter For a 2008 Saturn Vue
- The Swagman Trailhead 3 # S63365 is a fit for your 2008 Saturn Vue that you are having the Class III hitch put on. As a suggestion, if you are planning on carrying either womens, childrens, or alternative frame bikes, check out the Swagman Adapter Bar # 64005. When using this bar with a hanging bike rack the bike is transported level and provides your bike good ground clearance.
I have attached a short video reviewing the adapter bar.
The Curt Multipurpose Ball Mount # D210 will allow...
view full answer... - Parts Needed For Towing a Trailer With a 2006 Saturn Vue
- Yes, we have the T-One Vehicle Wiring Harness # 118418 which will connect in line on your 2006 Saturn Vue's tail light wiring. This will give you a 4-way flat connector for towing most small trailers which do not require electric brakes. If you have a trailer with brakes you will need our Kit # ETBC7 and a Brake Controller # RED52VR. I prefer this Redarc controller as the main portion of the controller is hidden behind the dash and you can make adjustments via the small control knob.
I...
view full answer... - Troubleshooting Emergency Flashers Not Working When Other Lights Do on Trailer Wiring Harness
- This is an extremely unusual problem, but there is something we can check to get started and see what the issue might be. You'll want to use a circuit tester like the # PTW2993 and test the yellow and green wires when the flashers are turned on; test this on the input of the # C56018 side between the vehicle and the converter box to see if there is power being supplied on those circuits.
If you've already done this, and that's what you were referring to when you tested, please let me...
view full answer... - Replacement Hub Assemblies for Demco Kar Kaddy Tow Dolly
- In order to select appropriate replacement hub assemblies you'll just need to match the part numbers or the characteristics of your hubs. You will need to match up your bearing and seal numbers from the original parts if possible, as well as the axle's weight rating (which should be indicted on the axle itself) and the wheel bolt pattern. The linked article shows you how to determine your bolt pattern.
The Demco website shows several models of their Kar Kaddy tow dolly but does not include...
view full answer... - Will Roadmaster Tail Light Wiring Kit with Bulbs # RM-155 Fit a 2008 Saturn Vue
- According to the Roadmaster, the Roadmaster Tail Light Wiring Kit with Bulbs, part # RM-155, will fit in the tail lights of your 2008 Saturn Vue.
The # RM-155 kit will require you to drill a 1-inch hole in the back of the taillight housing right under the red lens. It uses the standard #1157 bulb which measures 1.83 inches tall and .97 inches width of the bulb. The sockets measures .95 inches where it goes into the lens.
The instructions show to drill a 1 inch hole in the taillight housing...
view full answer... - Thule Speedway Bike Rack Part # TH961XTR for 2004 Saturn Vue
- Due to the way the Thule Speedway would be mounted to the 2004 Vue, you will not be able to open the rear door while the rack is in place. The lower clips attach to holes in the chassis behind the bumper.
If installed correctly, the rack will reliably stay in place. The installation is pretty easy and straightforward. The attachment hooks used are rubberized to prevent scratching the finish on your Saturn.
view full answer... - What Hardware is Included With the Curt Class III 2 Inch Hitch # 13591
- Our hitches ship with the all the installation hardware needed including bolts, nuts, washers, and fish wires if needed. Many of our hitch descriptions have pictures of this, but some do not. If you want to see the parts included, you can check the instructions for the hitch linked on the product page. I have added a link to the instructions below.
The Curt Class III 2 Inch Hitch, # 13591, for your 2007 Saturn Vue includes 6 hex head bolts, 2 carriage bolts, 2 spacers, 6 conical tooth...
view full answer... - Recommended Tow Bar and Flat Towing System for 2008 Saturn Vue XR
- For your 2008 Saturn Vue XR, the Blue Ox Base Plate Kit # BX3332 is a confirmed fit. I've linked a video to a 2013 Captiva which will install in the same way. These base plates will work well with the Blue Ox Alpha Tow Bar # BX7380 you referenced, and in fact that is my recommendation for your application.
If you are looking to complete your flat tow system on your Vue, I also recommend the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit # RM-15267. This will give you a clean...
view full answer... - Installation of Curt T-Connector Vehicle Wiring Harness # C56026 on 2008 Saturn Vue
- The Curt T-Conenctor Vehicle Wiring Harness, part # C56026, for your 2008 Saturn Vue has a circuit protected powered tail light converter (Modulite). This converter powers the trailer lights from a separate wire, with an inline fuse, that is ran to your vehicles battery. If you do not connect that separate wire to the battery you will not be able to get working lights on your trailer.
This harness uses the vehicle wiring as the switch to activate the trailer lights, only requiring about...
view full answer... - Troubleshooting Trailer Turn Signals Not Working with 2006 Saturn Vue
- First thing to try is unplugging the connectors and replugging them back in as sometimes it's just a matter of clearing out the connection so they can make better contact.
Next thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # PTW2993 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then...
view full answer... - What Size are the Bolts that Thread Into Weldnuts to Install a Trailer Hitch on a 2003 Saturn Vue
- There are a total of 6 bolts that thread into the factory weldnuts on a 2003 Saturn Vue to install trailer hitch # e98865 as well as 2 carriage bolts and matching nuts that fit other places on the hitch. The bolts that fit the weldnuts are M12x1.75x40mm.
But if you need new hardware then you will need # RHK. Enter the hitch number and manufacturer where indicated on that page to get the correctly sized and rated hardware for that hitch and vehicle.
If you are having trouble installing...
view full answer... - Where to Mount Converter Box When Installing Trailer Wiring for 2006 Saturn Vue
- With the install of the Curt trailer wiring harness part # C56018 that you referenced Curt recommends finding a flat spot inside the vehicle near the taillight to adhere the box to in step 6.
When we had the chance to install the similar Tekonsha kit part # 118418 on a 2006 Saturn Vue like yours we mounted the box in the driver side rear taillight area. If you check out the 1:00 mark of the video you'll see our installer mention this although it's not shown.
view full answer... - Hitch Recommendation for a 2007 Saturn VUE Hybrid
- Yes, I checked with Curt and the Curt Hitch part # 13591 that you referenced has been confirmed to fit all styles of the 2007 Saturn Vue so it will fit the hybrid models like what you have. I attached an install video for you to check out as well.
If you plan on doing some towing you might be interested in etrailer ball mount kit # 989900. It comes with 2 ball mounts; one with a 3/4 inch rise or 2 inch drop and one with a 2-3/4 inch rise or 4 inch drop. It also includes a 1-7/8 inch ball,...
view full answer... - Compatibility of Roadmaster XL Base Plates and Roadmaster Falcon 2 tow bar on 2007 Saturn Vue
- Yes, you could use the Blue Ox Base Plate Kit # BX3335 with your Falcon 2 tow bar # RM-520 with the use of Roadmaster Tow Bar to Blue Ox Brackets Adapter # RM-031.
Before doing that, however, keep in mind that the 2007 Saturn Vue would be able to use the Roadmaster XL base plates, though the exact model number depends on the type of engine in the Vue; for example, Roadmaster XL Base Plate Kit # 3139-1 fits the 2007 Vue 4-cylinder and hybrid models. The reason this is matters is because...
view full answer... - Will Thule Evo Raised Rail Feet Fit 2008 Saturn Vue and 2004 Honda Odyssey with Factory Rails
- The Thule Evo raised rail feet, part # TH710401, definitely fit both your 2008 Saturn Vue and 2004 Honda Odyssey that have the factory rails.
For the Saturn the recommend SquareBars are the 47 inch bars, part # TH712200, but the Odyssey fits the 53 inch, part # TH712400. There's a good chance either bars will fit both vehicles but they havent' been tested so I can't guarantee it at this point.
view full answer... - Recommended Class III Trailer Hitch for 2009 Saturn Vue
- I do have a great option for you, however the etrailer.com Trailer Hitch Receiver # e98865 that you referenced will not fit your 2009 Saturn Vue. This particular hitch is designed for the Saturn Vue up through the 2007 model year, so it will not line up to the frame rails of your 2009 model.
For your vehicle I highly recommend the Curt Class III Trailer Hitch # 13594, which features a nice hidden-crosstube design that allows only the 2" receiver to be visible (to maintain a sleek OEM...
view full answer... - If there is a Short Circuit Will Curt Converter Box Blow or Just the Affected Circuit
- Normally when there is a short circuit it will blow the converter box no matter what the brand is. But sometimes it will only affect the one function that shorted like what you have experienced. It could go either way but regardless of what does happen you would need to replace the converter to fix the issue.
We do have the plug in style T-connector # 118418 that you can use instead of a hardwire harness if you hare interested. I have linked instructions and a video for you to view.
You...
view full answer...
Go To Results