While we have replacement locks, we do not have the exact replacement keys for your original locks on your 2020 Winnebago Micro Minnie.
You still have the option to replace or upgrade your current locks with our selections like the Global Link RV Entry Door Locking Latch Kit # 295-000002. It also depends on what locks will be replaced, so I attached our selection below. view full answer...
The Wesbar Low Profile Trailer Tail Light # 403026 is the match for the drivers side to your Wesbar Low Profile Trailer Tail Light # 403076. view full answer...
My friends at Lippert have identified your axle as being a 3500 lb axle with a hub face to hub face distance of 88 inches and a 68.5 inch center to center spring seat distance.
Given that, we do offer an axle that would work for you with a slight modification. I'd recommend the Dexter Axle # T3584F-EZ-8974 which has an 89 inch hub face to hub face distance. This would mean that your wheel would extend out further by 1/2 inch on either side of the trailer, but that wouldn't be an issue... view full answer...
We do offer a replacement monitor power cable, the part number for that is # C-FOS07TAPK-006. Furrion confirms that the cable is compatible with the monitor used by your FOD43TA-BL camera system.
I've linked to a product description video for the cable. view full answer...
The reason your Firestone air bag wore such a massive hole in the side of it is that the kit you have installed was not designed to fit your 2001 Ford F-150 and instead was designed for a Dodge Ram truck. If you install the same air bag you have now you'll have same problem down the road.
The kit you should have installed on your truck was the Firestone part # F2320 which uses the Sport Ride bags that are a totally different design.
To answer your question though the exact replacement... view full answer...
Yes, the Furrion Chill Replacement RV Air Conditioner for Dometic Brisk Setup - 15,000 Btu - White # FR42PV will work perfectly for your replacement. It will simply connect to your Dometic wiring so it will utilize the control box and thermostat you have already replaced. view full answer...
I reached out to Extang and the Replacement Side Seal for Extang Tonneau Covers part # EX32560368 is the correct seal to replace the damaged one on your Extang Trifecta 2.0 Tonneau Cover. view full answer...
We do have what you need, as the only TruTrack that comes with the adjustment rods is the 15,000 lb/1,500 lb tongue weight Curt TruTrack Weight Distribution System with Sway Control # C17501.
To get the adjustment rods for this system you will need something different than what you mentioned; it will require the Replacement Hardware Kit for Curt TruTrack Weight Distribution System # C17554.
This comes with the adjustment rods as well as other hardware for the 15,000 lb system. view full answer...
With your Furnace and Air Conditioner turning on at the same time, there appears to be an issue with the thermostat as you stated. The Replacement Premium Wall Thermostat for Furrion Chill RV Air Conditioner - Single Zone - Black # FR33PR is designed for Furrion AC systems which replace the Dometic Brisk systems. It will allow you to select between furnace and AC. view full answer...
It looks like the Fulton Grease Cap - 1.786" Outer Diameter - 1-9/16" Tall # F001503 is going to be slightly too small for your needs. The closest replacement grease cap we have to your 1.934" OD size is the Fulton # F001524 which is 1.943" OD and 1-3/8" tall.
I've linked our entire selection of grease caps to this answer, the next closest size after that is the # TRAG-DC-196 which is 1.957" OD. view full answer...
Since the ball is 2 years old, it does not qualify for Curt's warranty. The Curt Pop-In Ball for Underbed Gooseneck Hitches # C60601 has a 1 year warranty on parts, in addition to a lifetime limited warranty against breakage or any type of manufacturer's defect-I'm not sure that this would qualify as a manufacturer's defect, but you can reach out to Curt directly. I've attached their warranty breakdown page as an FYI. view full answer...
To answer your question, both of the # ST70RB and the # STL72RB are 6-1/2" long x 2-1/4" wide x 2-3/8" deep lights; the main difference is that one is an LED light while the other is an incandescent. I was able to find some information on your TruckLite 60283 light and the best match to replace that light is the # ST70RB , since your trailer light system is wired for incandescent lights.
If you wanted to switch both lights over to LED, you would use # STL72RB but you would likely need... view full answer...
Thank you for the pictures!
The correct replacement lid for your roof vent assembly is the Ventline # BV0554-01 in White or # BV0554-03 in Smoke. I think the Smoke version matches your existing unit a bit better but it's completely up to you - both will work great as replacements.
I have attached an installation video that you can also follow along with. view full answer...
I may have a solution for you, but I was able to reach out to my tech contact over at Lippert and he says that the switch on the Lippert Smart Jack Electric Trailer Jack w/ Footplate - A-Frame - 22-1/2" Lift - 3.5K - Black # LC643589 is not a replaceable part. For that reason, if your Smart Jack is not still covered by the 1 year warranty on this part you will need to replace it.
You may first want to make sure that there isn't an issue with the connection to the battery if you haven't... view full answer...
Unfortunately, we don't offer a single replacement leg of that type that would have a motor on each leg.
Your best bet would be to replace your existing landing gear with something like the Stromberg Carlson # LG-3 or # LG-4 which has the same sized legs, 29-1/2 inches in length and and outer dimension of 2-1/2 x 2-1/2 inches. The landing gear have a 6500 lb combined capacity.
This system and its parts were designed to be compatible replacements for most of the other fifth-wheel landing... view full answer...
Most RV air conditioners use a standard 14-1/4 x 14-1/4 inch opening, which is what the Camco # CAM40480 is compatible with. You can easily confirm that this is the case with your existing unit by removing the air handler or grating and measuring the rough opening through the roof.
I'd also recommend an install kit like part # 344270KITW.
I've linked to an article that explains how to install a roof vent. view full answer...
We do not have replacement parts for the Summit Promaster bike rack nor do we carry that bike rack. Your best bet is to contact the manufacturer to verify if replacement parts are available.
I will make a few recommendations in case you decide to purchase a new bike rack in the near future. If you have a ladder on the back of your Winnebago RV with 1" tubing then you could use Stromberg Carlson Ladder Bike Rack - 2 Bike Carrier # LA-102. This can hold 2 bikes up to 25lbs each.
If you... view full answer...
You sure can!
For just the mounting hardware for your Draw-Tite # 24920 you will use part # RHK. Once on the product page you will need to type in the hitch model number (24920) then select "Draw-Tite" from the manufacturer drop-down menu. We will then send out the complete hardware kit specific to this hitch. view full answer...
Go To Results