Yes, I was able to pull up pictures of the Fan-Tastic roof vent 2000DM and it uses the same vent lid as the part # FVK1020-19 that you referenced. view full answer...
For your 2013 Itasca Meridian 34b Class A Motorhome which is built on a 2013 Freightliner XC chassis Roadmaster makes a front sway bar part # RM-1209-136 which is a fit and will work great but they do not make a rear sway bar. view full answer...
When measuring the frame width of your motorhome to ensure fitment of the Draw-Tite Multi-Fit Trailer Hitch # 5350 that you referenced, you will want to measure from the outside of one frame rail to the outside of the other frame rail. If you find that the frame width on your chassis is 24 to 46 inches, then this trailer hitch will work well.
This multi-fit hitch features a 2 inch receiver opening, a 5,000 pound towing capacity, and a 500 pound tongue weight limit. Its black powder coated... view full answer...
Yes the Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens part # 328-003-30LEM2 will be a great replacement for your factory lights. They are designed as a direct replacement for this very common light size found on campers. On occasion we will run into a situation where the mounting holes don't line up exactly and we have to drill new ones but this is very rare.
I highly recommend using Heat Shrink Butt Connectors part # DW05744-10 to make your connections... view full answer...
The Roadmaster Battery Charge Line Kit for Towed Vehicles part # RM-156-25 can be installed on a 2020 Jeep Grand Cherokee. If you will be pulling power from the vehicle's battery while in tow then it would be a good idea to use the charge line to ensure you don't have a dead battery when you arrive at your destination and are ready to unhook the vehicle from the motorhome. view full answer...
Yes, the Roadmaster Reflex Steering Stabilizer part # RM-RBK18-RSSA that you referenced is confirmed as a fit for your 2011 Itasca Ellipse Motorhome as long as it has air suspension and a solid front axle. I attached an install video for this kit for you to check out as well. The motorhome is different from what you have but the chassis is the same. view full answer...
We do have the lights you are looking for. I have attached a link to our product page for the 44 series lights we carry.
If you are looking for a Red clearance light you can use part # MC44RB. This light measures 4 inches long, 1-1/2 inches wide, and 15/16 inches deep. The mounting holes are spaced 3 inches apart.
For an Amber 44 series clearance light you can use part # MC44AB. view full answer...
The MaxxAir TuffMaxx Replacement Shroud for Coleman-Mach RV Air Conditioners part # MA00-325001 should be what you are looking for but I would not get caught up in all the different part numbers as there are more than one that will work. That said, the problem is that I don't know which series you have as I cannot look this up based on the RV info nor can I reference older part numbers very well. The above fits all Mach 1, 3, and 15s. If you don't know which you have I'd need to know the... view full answer...
I recommend going with the Furrion RV Tankless Water Heater # FR98SR for a replacement.
Tankless water heaters really are the way to go because you get on-demand hot water, higher heating capacities than traditional water heaters, and are much more efficient than regular gas units.
This particular unit has a heating capacity of 13,000 - 60,000 Btu which is much higher than your older Atwood unit, a wall thermostat which easily allows you to adjust water temperature, and has internal... view full answer...
So since you are carrying your bikes on a motorhome, you will need a bike rack approved for use by the manufacturer on the back of a motorhome due to it being a rougher, bouncier ride.
We do have one bike rack that is approved for use on a motorhome, can carry your 55 lb e-bikes, and is compatible with bikes that have fenders and a step-through frame, the Swagman Current 2-Bike Rack # S64678.
This is a frame-mounted bike rack, so because you have a step-through frame you will also need... view full answer...
You'll want to use a floor jack to get the rear axle off the ground and then use jack stands to support the axle so that you have enough access to install the rear sway bar part # RM-1139-149. The leveler jacks should be relied on as the only way to hold the motorhome off the ground but I would lower them anyway to use as a backup for in case the jack stands fail. Motorhomes are incredibly heavy so getting under one to work on it in any way is dangerous. As many fail safes as you can use... view full answer...
To level your Blue Ox Tow Bar I recommend the Gen-Y Adjustable 2-Ball Mount w/ Stacked Receivers # 325-GH-327 which has 15" drop or rise to be able to get your tow bar within the 3" safe zone on your 2011 Buick Regal. Since this ball mount has stacked receivers you will not have to use the included hitch ball, and can use your motorhome mounted tow-bar in whichever location needed to get within the 3" safe zone, and can use a bike rack or cargo carrier in one of the higher receiver openings... view full answer...
I suggest you go with the Adco Olefin HD All-Climate RV Cover for Class A Motorhome, # AD84ZR. This is the up to 40' fit, use the cinch strap at front and rear to pull that extra 18 inches in for a tight fitment. view full answer...
You can use Ventline Ventadome Trailer Roof Vent - Manual - 14-1/4" x 14-1/4" - Smoke. # V2092SP-29 for both your bathroom and kitchen vents. There is not a specific vent lid for 13" by 13" roof vents and this is the closest size; it is recommended to enlarge the 13" by 13" to the now standard 14" by 14" so that you will have a nice fitting lid.
Then you'll need a garnish; 2-1/8" # VA0445-34, 3-1/8" # VA0445-35 or 5-1/8" # VA0445-37 depending on the thickness of your roof. I also recommend... view full answer...
In a Class C motorhome addressing body roll/sway is a common issue. Suspension on the cutaway van chassis that most Class C's are built on is adequate with a van body on the chassis. However, when coach builders place a significantly different body on the chassis that obviously changes the dynamics and many OEM coach builders fail to upgrade/enhance those now less effective suspension components. We have two options available the Roadmaster Rear Anti-Sway Bar, # RM-1209-120 is a significant... view full answer...
Based on the dimensions you listed the LED RV Interior Can Light # DG52445VP is an exact fit for the puck lights you are replacing in your 2015 Winnebago Itasca Sunova. view full answer...
The SnapRing TireSavers Tire Covers # ST7000WH that you referenced is made of vinyl which can easily collapse and fold for storage in an RV bin or elsewhere. view full answer...
The Camco RV Rain Gutter Spouts w/ Extensions # CAM42134 (white) or # CAM42323 (black) are a universal style fit which means they will work great on your 2000 Itasca Sunrise 29A motorhome even though they were not necessarily designed specifically for your model. Essentially all motorhome gutter systems are similar enough that this would fit and work well. view full answer...
While we don't have locks for specific refrigerator doors, you could use a cable lock like the etrailer Cable Lock, part # e98891. It's 10 feet long and can wrap around the door handles. I've linked to a video review of this cable lock.
If you want something that can bolt onto the door and looks a little nicer, you can use the ToyLok Retractable Cable Lock, part # LC337120. view full answer...
Go To Results