So you can add a replacement lock core to your Thule Weekender 627 cargo box, but the lock core does need to be unlocked to be able to use the universal master key and install new lock cores with the Thule One-Key System Lock Cylinders # TH450200.
It sounds like yours may still be locked, and since you used a key (the right one based on the number - there does not have to be an "N" on front of it), but it doesn't unlock, the only option is to use a locksmith to remove the lock.
I have... view full answer...
Take a look at your existing 7-way, you'll need to stick your head under the rear bumper so you can see the rear of the connector. If the factory tow package harness can be unplugged from the rear of the 7-way (see photo), then I'd recommend using a T-connector like # 118384.
You'd simply unplug the tow package harness from the back of the existing 7-way, and plug the # 118384 inline between the tow package harness and the 7-way. I've linked to a video showing a typical installation.
If... view full answer...
Thank you for the picture of the tag on your axle!
I was able to use that when I reached out to my contact at Lippert who confirmed that the correct lift kit for the axle on your 2018 KZ Sportsmen Classic 130RB is part # LC425750. view full answer...
If you have a 4-way trailer wiring harness on your motorhome most likely it has already had the turn signal light circuits converted so that the 4-way would function properly. What you can do is test the 4-way with a circuit tester like part # PTW2993to verify this. I attached a video that shows how to do this.
It is possible that someone wired up a 4-way to your motorhome incorrectly though. If so, then you would need to use a converter harness like part # HM48895 to properly wire your... view full answer...
We do carry part # 13-140-3 equalizer bars.
These are designed for 10,000 lb axles and 2-1/2 inch slipper springs, and can be used on either the left or right hand. view full answer...
I'll start out by saying that trailer jacks aren't necessarily going to be camper specific, so I don't really have a way of determining which jack came on that camper originally. However, you've mostly likely got an A-frame tube jack with a 2" diameter tube (1-3/4" inner diameter), so you could likely use something like the Replacement Caster Wheel for Ultra-Fab Manual 2" Trailer Jack - Qty 1 # UF49-954035 to replace your old wheel. This is a 6" diameter wheel, so it would be slightly smaller... view full answer...
We have many types of trailer roof vents and vent parts but we do not have a way to look up the vent originally installed in your 1992 Palomino Filly so I suggest confirming the dimensions. Most often square roof vents are 14 x 14-inches and fit roof openings that are generally 14-1/4 x 14-1/4.
Based on photos of your pop-up that I could find it appears you do have a 14 x 14 vent so I linked for you our entire range of trailer vents in this size. We have manual vents, 12V powered vents... view full answer...
I'm sorry to hear your vacation was cancelled but we do offer complete replacement hardware for the Curt Trailer Hitch Receiver # C13146 that fits your 2017 Honda Pilot.
To get the hardware, which includes the washers and M14-1.50 bolts, what you will need is the Replacement Hardware Kit for Trailer Hitches # RHK.
All you need to do is click # RHK, enter "C13146" in the "Hitch Item Number" box, and select "Curt" from the drop-down menu and you'll get the complete hardware needed for the... view full answer...
We can help you with replacement hitch installation hardware for your Class III Draw-Tite # 75599.
All you need to do is enter the part # RHK into our search box. Then simply enter the hitch part # 75599 in the box and choose Draw-Tite from the manufacturer drop-down menu. We'll then put together all the correct fasteners for your hitch.
You'll need a torque wrench to ensure all fasteners are secured to the manufacturer's specs; this information is included in the linked instructions.... view full answer...
To determine the correct replacement spring you will need to go by the measurements of the existing springs. This is best done with the weight off of the spring you are measuring either by removing it or by jacking up one side of the trailer.
We have replacements that are rated for 3,500 pound axles. All of the springs on the trailer should be replaced at the same time so that the trailer doesn't have some good springs and some worn out ones. That could lead to poor ride quality and uneven... view full answer...
We do have a handful of replacement fender skirts that I've linked for you to filter through. These aren't fitguided so I don't know what exactly will fit your 2018 nuCamp T@b 320S, but something like the 58" long x 2-1/4" wide Phoenix USA Flexy Flares # PX52-170 should work just fine. I recommend measuring the length of your current fenders along the inside of the wheel well to make sure you choose something with the correct length. view full answer...
Your old Yakima RocketBox has mounting holes that are 4-1/2 inches on center, so there isn't a direct fit we carry. Instead I recommend using the Replacement Hardware Kit for Searsbox Cargo Box # TH05603. This will fit your Malone Aero bars like # MPG215 on your 2015 Toyota RAV4 as well as the factory bars on your 2008 Honda Pilot.
I recommend using the gasket maker # LT37467 to seal the extra holes in your box to prevent water entry at the unused locations. view full answer...
I believe the vent cover you are looking for is the Replacement Dome for Fan-Tastic Vent RV Roof Vents - Tinted # FVK1020-19. I've attached a video to assist.
I've also attached the 4 hinge options in a photo to give you a clear look at the options. view full answer...
Replacement Left Side Fender for Yakima Rack and Roll Trailers - Qty 1 # Y8880164 and right side # Y8880163 are intended to be priced equally. The reason why they are not at this moment is that the right fender is on sale in our system. Why they both aren't is simply because there has been a higher demand for the left side. So it is logical from one perspective and illogical from the other. Bottom line, you save the extra money on the right side versus them both being the current cost... view full answer...
Curt T-Connector Vehicle Wiring Harness # C56291 includes both a red 10-amp mini blade fuse for the red fuse holder on the harness and a pink 30-amp box fuse for the fuse box in the engine compartment. Both fuses are shown in the linked photo. You'll have no trouble finding these at your local auto parts store. view full answer...
I have a replacement option for you, but after speaking to my contact at Tekonsha I confirmed unfortunately you can not buy any of the parts of the Tekonsha T-One Vehicle Wiring Harness for Factory Tow Package # 118558 for your 2013 Honda Pilot separately.
Instead the only option to replace the wiring parts you are missing, is to purchase a new complete harness using # 118558. view full answer...
For a 4-way trailer wiring kit confirmed as a fit for your 2015 Honda Pilot we have the Tekonsha kit part # 118558 which would be exactly what you need. This is a custom install kit that plugs into your vehicle's exsiting wiring to provide you with a 4-way. view full answer...
So it sounds like your 2012 Honda Pilot did not come with the factory tow package. You are going to need more than just the converter box. You are also going to need some relays and at least one fuse. Since the converter is not available by itself you would have to get the complete kit, # 118265, or # 118558. I wish we did just have the converter by itself but at this time it is not for sale as a separate part. view full answer...
Roadmaster part # 910021-00 is the Quick Disconnect Tow Bar Base Assembly for all Roadmaster tow bars (except the Tracker # RM-020). This part includes the support bar, quick disconnects (both motor home and car sides) and the pins to attach the tow bar to the support bar. If you do not need the quick disconnects and pins, you can instead use part # RM-067. view full answer...
We do carry replacement rubber cradle straps for the many bike rack brands we carry, including Thule. Do note that sometimes the original design strap will have been replaced with a new version, that while still compatible, may appear different. Since your rack is an older model this may be the case.
The linked page will display all of the replacement rubber strap items we offer for brands like Thule, Yakima, Swagman and others. If you click on Thule you'll see all of their replacement... view full answer...
Go To Results