Expert Answers about Dutchmen
- Crossbar Recommendation for 2024 Toyota Tundra with RetraxONE XR Tonnea Cover Installed
- Hey Parvez, glad I could help! So the Rhino Rack Vortex Crossbars for Retrax XR tonneau covers part # RRVA180B-RRRLT600 was designed specifically to work with your RetraxOne XR tonneau cover so it is going to definitely have enough clearance above your tonneau.
This has a 220 lb dynamic weight capacity which means it can carry 220 lbs on the rack when on the road.
So your truck bed width is 59 inches and the bars of this kit are 71 inches so that would put the bars about 5 inches past...
view full answer... - Replacement Waste Valve And Fresh Water Pump For A 2012 Forest River Sport Surveyor
- Hello Sandy thanks for the picture. The valve in your picture appears to be a double waste valve like the Valterra Motorhome San Tee # T18A. This valve uses a 3" spigot with a 1-1/2" hub off to the side, both of which are the standard valve sizes. You could always measure the current valve to confirm this, but based on what I can see in your picture, the # T18A will be exactly what you need.
As far as a fresh water pump, they are all fairly universal, it really comes down to your requirements,...
view full answer... - Better Bath RV Kitchen Sink LC389910 Flange Width
- Hey Marty, yeah the width of the flange around the Lippert sink part # LC389910 is 1 inch.
view full answer... - Recommended Replacement Galvanized Trailer Tire/Wheel Combo for a ST205/75R14 Tire
- Hey Wayne, I did some looking around and it does not look like we carry any Endurance tires in the size you're looking for. We do have the Goodyear Endurance ST205/75R15 Radial Tire # LH53FR which will work with a ST205/75R15 tire but it's also not galvanized.
Instead, I'd recommend checking out the Loadstar ST205/75D14 Bias Trailer Tire with 14" Galvanized Wheel # AM3S450 which does have a galvanized wheel, will work as a direct replacement since it's the same size you're looking for,...
view full answer... - Weight of the Head and Base for the PullRite OEX Super 5th Wheel Hitch
- David, the hitch head # PUL39ZR for the PullRite OEX Super 5th-Wheel Hitch for Chevy/GM Prep Package # PUL36ZR weighs 84 lbs, and the base # PUL59ZR weighs 81 lbs.
view full answer... - Awning Options For Square Crossbar Roof Rack on Jayco Trailer
- Hi Steve,
Thanks for that info and it sounds like you have Thule square crossbars, as those are the same 1-1/4" width you mentioned. You can certainly mount an awning to your crossbars, it just depends on what your crossbar spread is, and how large of an awning you want.
I'll go ahead and list out the options for you by size, and tell you what minimum crossbar spread is needed (if you aren't sure what spread you have, just measure the distance between the crossbars to get that distance).
-...
view full answer... - Weight Capacity of Thetford Aqua-Magic Style II RV Toilet
- Hi Manny,
I reached out directly to Thetford to get the answer for you, and found out the weight capacity is 300 lbs for the Thetford Aqua-Magic Style II RV Toilet # TH49FR.
view full answer... - How to Determine Lights For Trailer
- Hi Glenn,
I'm sure we have lights for your Karavan trailer but have no way of knowing specifically what lights are on any one trailer. So you will need to measure your current tail lights and find the ones that most closely match your measurement.
For example, the LED Trailer Combination Tail Light # STL39RB is 4-1/2" tall x 5" wide x 2-1/2" thick.
I have added a link below to our entire selection of trailer lights which you can filter through by size.
view full answer... - Replacement Slider
- If you have 12" wide tracks you can use the JR Products Screen Door Slider - 12" - Black # 37211175 you were looking at. We don't have anything that is 11-1/2" tall so I recommend measuring the width of the tracks for the slide to be sure.
view full answer... - Will Kuat Piston Pro and Piston Pro X Fit New Ford Bronco With Rear Mounted Spare Tire
- The answer to your question depends on where the hitch sits on the Bronco and how far the tire sticks out. This is not information that we have so you will have to use our measurements to compare on your Bronco. The distance from the center of the hitch pin hole to the closest part of the Kuat Piston Pro # KU76ZR and Piston Pro X # KU98VR is 10-1/8". If this is enough to clear the spare then it will work.
More than likely you will need additional clearance. In this case, the best solution...
view full answer... - Is It Okay to Have Ball Mount 1" Off of Towing Trailer Level
- Thanks for reaching out, Michael!
As long as you're within 1" of being level you'll be just fine.
I will say that in your case I'd recommend picking up a 0 drop ball mount like the Flint Hill Goods Tri-Ball Mount # FHG62VR so you're 1" above what you need rather than 1" below. Reason being that when you couple up to the trailer your vehicle ball mount will naturally squat just a little so if you're 1" above what you need, it will help level things out a little once everything is hooked up.
view full answer... - Correct Solera RV Slide-Out Awnings for a 2021 Jayco Eagle HT
- Hey Victor, thanks for reaching out!
If the slide outs on your 2021 Jayco Eagle HT measure 87.5" and 145" outer edge to outer edge then you'll want the following White slide out awnings:
- Solera RV Slide-Out Awning - 91" Wide # LCV000163288
- Solera RV Slide-Out Awning - 145" Wide # LCV000163298
These have width ranges that fit what you measured for your slide outs, and since you already have the prep kits installed, the installation process will be a bit quicker for you!
view full answer... - Is the Replacement M6 x 80 mm Carriage Bolt for Thule Compass Kayak and SUP Carrier Fully Threaded
- The Replacement M6 x 80 mm Carriage Bolt for Thule Compass Kayak and SUP Carrier # TH58DH is going to be a full threaded carriage bolt with an M6 head and an 80mm length.
view full answer... - Trailer Hitch for Carrying Electric WheelChair on 2012 Chevrolet Impala
- They probably told you that because of the lower capacity for Class I and II along with limited availability for carriers that fit a 1-1/4" hitch. The only hitches available for your 2012 Chevy Impala are Class II like the # 36407 which has a tongue weight capacity of 300 lbs.
Assuming the weight of your wheelchair does not exceed this 300 lb limit, or the tongue weight capacity of your vehicle, it would be able to hold the wheelchair. You will also need to find a carrier that can hold...
view full answer... - What are the Dimensions of the DeeZee Specialty Series Trailer Tongue Tool Box DZ91716?
- The DeeZee Specialty Series Trailer Tongue Tool Box item # DZ91716 measures 34" long in the back, 16" long in front, 14-1/4" wide and 18" tall. The lid measures 36" long in the back, is 15" wide, and adds 1" to the overall height.
I got these measurements from DeeZee and have linked a diagram below.
view full answer... - Availbility of Trailer Hitch for RV
- The RV hitches are fairly universal so I can give you some options and you can decide based on dimensions and the style you want. For a frame mounted hitch you will need to know the frame width of your RV. The Curt # C13701 fits frames 18" to 51" wide and the # 13703 fits frames 22" to 72" wide.
You could also choose to go with a bumper mount hitch. The Curt # E-100 fits a 4" x 4" bumper and the # C19101 fits a 2" x 4" bumper. You will also need to find the capacity of your RV/bumper...
view full answer... - Can You Carry 2 E-Bikes Behind a 2008 Toyota Yaris?
- As there is only a class I trailer hitch receiver like the Curt # C11480 available for your 2008 Toyota Yaris, you are going to want to use the Thule Epos Bike Rack # TH99XE. This rack is a class I and is capable of holding 2 bike up to 140lbs with a maximum of 75lbs per bike if you had one weighing 75lbs and another 65lbs or less. The rack itself only weighs 38.1lbs so with your 60lb bikes you are only at 158.1lbs which is below the 200lb capacity of the Curt class I receiver. The uprights...
view full answer... - Can 26" Double-Eye Leaf springs Replace 25-1/2" Double-Eye Leaf Springs
- Hi Tim,
A half inch difference between your old springs and some new springs would be well within tolerance so you would not need to replace the equalizer. The equalizer end of the # e27SR will sit slightly more in towards to the center hanger but it's such a small amount that it won't make a huge difference. You will want to replace the U-bolts when swapping out the leaf springs since they get stretched when torqued down and shouldn't be reused. With you having a 4,400lb axle it should...
view full answer... - Overall Height Of Buyers Products 50 Ton Air Compensated Pintle Hook # 337PH50
- I went to our warehouse and measured the Buyers Products 50 Ton Air Compensated Pintle Hook # 337PH50 to get the height dimensions. The overall height of the pintle when open is 12" and when closed is 9-1/2". I also took a measurement for the height from the center mounting hole which you can have as reference point if your recessed area already has the holes drilled. When open it is 9-1/4" to the top of the hitch and 6-1/2" when closed. I have included images below with these measurements...
view full answer... - SnapPad Jack Pads For A 2024 Jayco Pinnacle 5th Wheel Trailer
- There's unfortunately not a guide to tell us the sizing of your trailer's jack pads so you'll want to measure and note the shape of each pad. I've run into numerous situations where the front and rear pads were either different sizes or shapes to work with the space available.
The SnapPad # SN88FR you were looking at are designed to fit four 9" round pads and two 12" round pads. If you can let me know what your shape and dimensions are I'd be happy to pick out the correct package.
view full answer...
Go To Results