Replacement Waste Valve And Fresh Water Pump For A 2012 Forest River Sport Surveyor

Question

Question:

I have a 2012 Forest River Sport Surveyor. I need to replace the holding tank valve. I have sent a pic of what i need as the handle on the I believe grey water valve broke as well. Next I believe I need a new pump that pumps water from fresh water tank. Thanks

asked by: Sandy M

1

Helpful Expert Reply:

Hello Sandy thanks for the picture. The valve in your picture appears to be a double waste valve like the Valterra Motorhome San Tee # T18A. This valve uses a 3" spigot with a 1-1/2" hub off to the side, both of which are the standard valve sizes. You could always measure the current valve to confirm this, but based on what I can see in your picture, the # T18A will be exactly what you need.

As far as a fresh water pump, they are all fairly universal, it really comes down to your requirements, such as the gallons per minute (GPM) or PSI rating you are needing. A really common option for smaller campers like yours, is the Seaflo Diaphragm Pump # SE58FR with will flow at 3 gallons per minute and has a max pressure of 45 PSI. There should be a sticker on the current pump with the specs. The link below will show you our full selection of fresh water pumps if you are looking for something different.

expert reply by: Jesse M

1

Waste Valve On A 2012 Forest River Surveyor Sport
(click to enlarge)

Answer 1

The differences between the three Double Waste Valves you mentioned comes down to the differences between hubs and spigots for their fittings. Hubs fit over spigots. The part #T18 has a 3 inch hub and a 3 inch spigot. The part #T18A has a 3 inch…

view full answer...

Answer 2

By "mobile home type bolt pattern" I believe you are talking about a 5 spoke utility bolt pattern such as what is on the Dexter Trailer Hub and Drum Assembly - 6,000-lb and 7,000-lb Axles #8-174-5UC3. To measure your axle from hub…

view full answer...

Answer 3

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…

view full answer...

Answer 4

What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…

view full answer...

Answer 5

Assuming your Sprinter has the factory tow package with the 7-way at the rear bumper, in addition to the #RED24FR Redarc Tow-Pro Liberty Brake Controller, you'll also need the #3063-P wiring harness and the #331-TPH-017. The connector to…

view full answer...

Answer 6

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to…

view full answer...

Answer 8

I do have an option but Glo-Brite is no longer in business so you won't be able to get any replacement parts for these lights such as lenses. The only option you have would be a full replacement for which the most similar option we offer is…

view full answer...

Answer 9

The amount of bow that's put into trailer axles like the #7359765 is based on about how much a trailer is typically going to weigh that has a 3,500 lb capacity. So there's a bit of approximation and obviously it can't be…

view full answer...

Answer 10

A 4-way trailer connector will have four functions which means it will also have four wires for the exception of wishbone harnesses. These four functions are ground, tail light, right turn, and left turn. The ground function will usually be…

view full answer...

Answer 11

The two sizes you mentioned are pretty similar and fit many of the same 15 inch wheels. The 205/75-15 fits rim widths of 5 inch to 6-1/2 inch whereas the 225/75-15 fits widths that are 5 inch to 6 inch. The 205 is 27.1 inches tall and the 225 is…

view full answer...

Answer 12

The Champion 9,000-Watt Dual Fuel Inverter Generators w/ Parallel Kit, #CH49FR has the same power output specs regardless of type fuel used. There is a starting (surge) power output of 4,500 watts/37.50 amps with a running power output of 3,500…

view full answer...

Replacement Waste Valve And Fresh Water Pump For A 2012 Forest River Sport Surveyor

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching